JED8430BDF18 Jenn-Air Cooktop - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Timothy from huntsville, AL
- Parts Used:
- 7920P202-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Cracked Galss Stovetop
1. Removed potand pans from under stovetop.
2. Disconnected exaust duct.
3. Raised the stove and placed wooden blocks under.
4. Unscrewed old top,and removed.
5. Placed new stovetop on stove, screwed into place.
6. Fresh caulk around opening.
7. Lowered stove into place.
8. Reconnedted duct work.
2. Disconnected exaust duct.
3. Raised the stove and placed wooden blocks under.
4. Unscrewed old top,and removed.
5. Placed new stovetop on stove, screwed into place.
6. Fresh caulk around opening.
7. Lowered stove into place.
8. Reconnedted duct work.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Johnnie from Daphne, AL
- Parts Used:
- WPY706012
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Replace Grease Filter For Downdraft Stove Top
Lift off blower vent cover. Lift out old filter. Clean walls and bottom of down draft using degrease soap and warm water. Dry. Discovered my grease filter will not install diagonally as shown in unit manual. Decided to drop into downdraft and put in front of fan suction. Found this left a gap at the top of fan suction that was not covered by the filter. Cut piece of wood 1 inch thick and width and length to drop down in the downdraft and lay on bottom. Set filter on top of wood in front of the fan suction. Verified that fan suction would pull filter tight against the opening by turning fan on and off. Put vent cover back over downdraft and told wife I was done.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mary H. from Appleton, WI
- Parts Used:
- WPY706012
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Filter was starting to come apart from frequent cleaning.
I removed the center vent and inserted the filter...easy as pie...I went to your website and everything was there in an easy to follow way that even I could understand, my husband was totally impressed that I took care of it on my own....silly man.....it was so easy and delivery was extremely quick....so simple....thank you for making it so!!!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ernst from portland, OR
- Parts Used:
- WP7739P121-60, WP74009254
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
variable speed switch was not working any more.
Went well, no swett
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kalman from Castle Rock, CO
- Parts Used:
- WP7739P122-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The Fan Knob that was original factory stopped popping up
1) Take the old knob off by pulling straight up 2)Make sure to completely remove parts that may have stayed in the hole 3) push new Fan Knob on make sure to line up properly for the D. Don't be nervous if it looks a little different than the original factory. Much better design and this company shipped when promised. Very easy to see what you need and no hassles.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Samuel from San Antonio, TX
- Parts Used:
- WP74009254
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
Knob stem broke off at the base near the switch
Removed stove top from the counter. Removed the glass frame and glass from the top. Removed the broken switch. Replaced with the new switch. Reassembled the unit and replaced it in the counter top.
One problem is the switch only fits in the space one way because of the first burner light. When installed the only way the knob fits on the switch stem makes the dot on the knob backwards. It now shows to be on medium speed when it is off.
One problem is the switch only fits in the space one way because of the first burner light. When installed the only way the knob fits on the switch stem makes the dot on the knob backwards. It now shows to be on medium speed when it is off.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Louise from Birmingham, AL
- Parts Used:
- WPY706012
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Worn grease filter
Replaced the filter which required no tools.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gregory from Prospect, CT
- Parts Used:
- WP74009254
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Nutdriver, Screw drivers
Fan switch only fits in one way and makes knob point to medium setting when off. The switch did not come with a mounting nut and the original in Jenn-Air didnt match.
Lifted cooktop out of cabinet, removed flange around glass cooktop, remove glass and access the fan swicth. I used teflon tape to get original mounting nut to stay tight on the plastic fan switch.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joseph from San Jose, CA
- Parts Used:
- WP74010839
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken control knob
Put new knob in place and threw broken one in trash/
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Elmo from Landrum, SC
- Parts Used:
- WP7739P122-60
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
broken fan knob assy
I used needlenose pliers to remove part left on shaft, regular pliers are too big. The original part had a metal insert so there was some rust and build-up on the shaft. I cleaned it with WD40. The new knob took a good bit of hand pressure to install.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joseph from North Kingstown, RI
- Parts Used:
- WPY706102, Y706061, WP74008248
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Screw drivers
Water had leaked into the switch shortting it out
Shut off breaker.Disconnected exhaust fan duct.Disconnected main feed wire.lifted stove out of counter.Removed screws from stove top.Remover glass top of stove.removed switch and made a diagram of wires.removed wires.reassemble in revirse order.Very easy everything was exactly the same as the parts I had removed.Thank you
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RIK SANTAGUIDA from Evergreen, CO
- Parts Used:
- WPY706012, WP74010839
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
the knobs had melted over thim
I put the new knobs on the posts.Dropped in a new grease filter. All done!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jim from BOERNE, TX
- Parts Used:
- WP7739P122-60
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
Knob was broken and would not stay on.
I at first tried to put it on the stem but it would not go on and stay. I went to this website and read several instructions and realized i had to remove more of the old know. I took out the inside part but still no go. I them took out the outer sleeve and was able to install and works great. Don't be afraid to keep taking the old parts out until you are down to just the post. Wife is very happy now. Thanks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Katherine from Arcadia, CA
- Parts Used:
- WP7739P122-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
Fan knob broke
Read the other folks descriptions of how they pulled out the leftover parts with needle nose pliers after they figured that the new knob would not fit with those other parts still on the range top. Took the leap of faith, pulled the parts out until I got to the D knob and slid the new part right on.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from Walla Walla, WA
- Parts Used:
- WP7739P121-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
broken knob
used pliers to remove broken knob and push new one on with my hand
Was this instruction helpful to you?
Thank you for voting!