JGC4430BDS14 Jenn-Air Cooktop - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Anna from MONROVIA, CA
- Parts Used:
- WP7733P382-60
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
My cooktop knob melted
I had used a pan too large for the middle burner - result: melted knob. Just pulled the old one off (up and straight) and then pushed the new one down firmly. Make sure the indicator line is pointing at you, so the flat side of the spindle matched the flat side of the hole on the knob. Easy peasy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carolyn from St. George, UT
- Parts Used:
- WP7518P465-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
black dirty burner grates
replaced grates
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- RAM from SAN DIEGO, CA
- Parts Used:
- WP7527P028-60, WP400021-1
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
No ignition
First I drilled out the screws on the burner as they were fused. I opened the stove top cover to access the underside of the burner. Removed the orifice holder, by disconnecting the gas line with a line Wrench and the electric cord.
The trick is to be careful with the gas line. Also when you go to replace the orifice holder you will notice that the holes are not threaded. The metal is soft and you're supposed to just screw the screws into the holes and let them bite into the metal. Then you reattach the gas on the electric and put the stove top back together.
The trick is to be careful with the gas line. Also when you go to replace the orifice holder you will notice that the holes are not threaded. The metal is soft and you're supposed to just screw the screws into the holes and let them bite into the metal. Then you reattach the gas on the electric and put the stove top back together.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from ROGERSVILLE, TN
- Parts Used:
- WP7733P381-60
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
One control knob got partially melted by a hot pan touching it.
I never did receive the part. It was a knob. Part numberPS11744700. Must've got lost in the mail. Thanks. Thomas Horne, 266 Eedmont Ct., Rogersville,Tn 37857?............P.S. The cost of it cleared my bank.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles from Buena Park, CA
- Parts Used:
- W11087445
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Wrench (Adjustable)
Gas explosion due to bad Gas Pressure Regulator
First step is to turn gas off to cook top and also disconnect power to the unit. Than using a crescent wrench disconnect the gas line going to the unit from the Regulator. Than again using the crescent wrench disconnect the regulator from the bottom of the unit. Next remove the nipple that connects the gas line to the regulator from the old unit. Apply new pipe dope to the threads and screw it into the new one and tighten down. Next install the regulator to the unit and install the gas line to the regulator. once done with the install you can now plug the unit in and turn on the gas. You are now ready to use the cook top again
Was this instruction helpful to you?
Thank you for voting!