Models
>
A125B
A125B Jenn-Air Cooktop
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for A125B
Viewing 1 of 1Keep searches simple, eg. "belt" or "pump".
$13.95
This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.
In Stock
$219.98
This surface element is for ranges.
The surface element supplies the heat to a cooking area on top of the range.
Unplug the range or shut off the house circuit breaker for the range before insta...
In Stock
This is a burner cartridge terminal block for your range/cooktop. If you are having trouble with your elements heating up, this part may need to be replaced. It does not come with spades or wiring. Th...
In Stock
Special Order
In Stock
$16.22
This part fits inside your range's terminal block to act as an insulator for the contact spade.
Special Order
Special Order
$4.68
Sold individually. This screw is half of an inch long. It is made of metal and it is intended for use with some Maytag brand ranges.
Special Order
This wiring clip is an inch long, and is made entirely of metal. This clip is used with ranges and cooktops.
No Longer Available
Special Order
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for A125B
Viewing 1 of 1Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- paul from trumbull, CT
- Parts Used:
- W10823698
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers, Socket set
No heat on burner
Turned off electricity! Pulled stove out -lifted up glass top(carefully) simply removed burned out coil and replaced it with new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Johnny from Henderson, NC
- Parts Used:
- W10823702
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
6" burner on the radiant surface started smoking and burned out.
Remove plug in unit from stove top. Turn over and remove the 7 screws from the 4 sides only. Turn back over holding unit together manually. Remove the glass top gently and lay it aside. Remove two wires that are plugged into the old unit, remembering which belongs where. You might want to remove one at a time and connect to new unit.
... Read more
Place new unit in between the three guides. Make sure the other unit is aligned also. Place glass top back unto unit and replace the 7 screws. Put unit back into stove top and test. Finished in less than 15 minutes with no issues.
Read less
Was this instruction helpful to you?
Thank you for voting!
The top would not heat,large or small eye.
Removed the bottom cover and replaced the burned contact spade. Cleaned the wires and adjust the contact holder.
Was this instruction helpful to you?
Thank you for voting!