Models > PP962TM4WW

PP962TM4WW General Electric Cooktop

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for PP962TM4WW

Viewing 1 of 1
Keep searches simple, eg. "belt" or "pump".
This 12-inch haliant surface element fits under the glass top of flat cooktops and ranges, providing heat to the cooking surface. It’s sold individually and replaces a non-heating burner. To install, ...
In Stock
Order now and your part arrives by May 29
$15.26
This screw is sold individually.
In Stock
Order now and your part arrives by May 29
No Longer Available
Sold Individually. This knob takes a double-flat shaft.
No Longer Available
This part goes between the infinite switch (under the cooktop) and the knob.
No Longer Available
In Stock
Order now and your part arrives by May 29
$52.50
This roll contains 108 inches of tape.
In Stock
Order now and your part arrives by May 29
This dual radiant surface element fits glass-top ranges and provides two heating zones for different pan sizes. It operates at 240 volts with dual wattage for efficient cooking. Replace it to fix issu...
In Stock
Order now and your part arrives by May 29
Special Order
Special Order
Special Order
No Longer Available

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for PP962TM4WW

Viewing 1 of 1
Element will not heat
Fixed by these parts
Fixing Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
John from LEWES, DE
Parts Used:
WB30T10126
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers
9in portion of heating element inoperable
first ,troubleshot switch--it was ok. next,troubleshot triple element & found that the 9in portion had an open in the heating element itself ordered .new element,installed it .Works like new!
20 of 28 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Richard from WOODLAND, WA
Parts Used:
WB30T10126
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Center Burner of a triple element wasn't working
Been procrastinating putting in the new element but decided to do it yesterday even if it meant eating breakfast out. Twenty minutes after starting , breakfast was cooking, at home on the new element. Two screws out, switch wires, snap on retainers, replace two screws and you're done!
10 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Larry from Stevensville, MD
Parts Used:
WB30T10135
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Outer element not working
Turn off breaker to stove. Remove 2 screws in front under stove top molding. Raise stove top from front on hinges in back. I used a piece of wood to support top up while I worked on burner. Remove screws holding old burner in place. I found my problem on the old burner - the outer element had been shorted and fried. Carefully remove e ach wire and reinstall in new burner in proper location. Reinstall burner and stove top with old screws.
6 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!