Models
>
ZGU385NSM2SS
ZGU385NSM2SS General Electric Cooktop
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for ZGU385NSM2SS
Viewing 2 of 2Keep searches simple, eg. "belt" or "pump".
$12.49
Sourced directly from the manufacturer, this OEM replacement grate foot is for ranges and cooktops. The grate foot attaches to the bottom of the burner grate to prevent the cooktop from being scratche...
In Stock
In Stock
In Stock
In Stock
On Order
In Stock
$135.65
The control transformer provides power to the spark module and burner ignition switches to light the burners.
In Stock
In Stock
In Stock
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for ZGU385NSM2SS
Viewing 1 of 1Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Kathryn from Star City, AR
- Parts Used:
- WB02T10461
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Grate Foot had worn out
A rubber grate foot on my range top had worn out. I pulled the worn foot out and installed the new grate foot with no tools or accessories. Good as new! Now I don't have to worry about the grate scraping my range top and scratching the paint. I also ordered extras so I won't have to wait if another wears out.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Anthony from Orlando, FL
- Parts Used:
- WB13T10077
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Igniter on one burner wasn't working consistently
Fairly easy repair. Remove the grate, then remove the loose fitting burner assemblies. Unscrew 5 screws using Torx (star) screwdrivers - 3 along the ring top and 2 on the inside flat portion of the ring. You'll need 2 different size Torx screwdrivers. Once the screws are removed, lift that piece. It may be stuck from years of baked-o
... Read more
n spills, but there's nothing else mechanically holding it. pull off the electrical lead, which is just held with a compression fitting. Use needle-nose pliers to pull off the C-clip holding the igniter in place. Careful not to lose the little spring that the C-clip holds in place, though it's not really under a lot of tension. Change out the igniter and reassemble everything. I used the pliers to push the clip back in place. All set - works like new.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Anne from Jacksonville, FL
- Parts Used:
- WB02T10461
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
After my housecleaner had been here, I noted that 2 of the little rubber feet were missing from the top grates.
I was pretty upset as the grate wobbled, so I went on line and looked for GE Profile parts. To my amazement, I found the little rubber feet quite easily, and within 2 days they were here at my home. I simply had to stick them in the holes; however, I noted that they did not fit real tight, so I removed them and shot a little glue on the
... Read more
m, and they have been in place ever since. Thanks to you guys, I am a happy camper now!!!
Read less
Was this instruction helpful to you?
Thank you for voting!