JGP331EM3 General Electric Cooktop - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Steve from Broken Arrow, OK
- Parts Used:
- WB32M10
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Drip pans needed to be replaced.
Simiple repair. Determined drip pan size (sm, med., lg.) removed 2 screws holding drip pan, placed gasket around new drip pan and installed. Repaired took less than 5 minutes.
Was this instruction helpful to you?
Thank you for voting!
Large and small Burner Drip Bowls needed to be replaced
The drip bowls of my stove had to be replaced. The tough job about this is that the bowls need to be ordered which we did. The order was sent to my house within a couple days. The drip bowls were replaced and they look and work just fine. The gas stove is about 10 yrs old and it needs the parts special ordered now. I used to wash and use a bit of elbow grease but this time it required too much effort. So an easy replacement did the trick.
Was this instruction helpful to you?
Thank you for voting!
Porcelain chipped around screws
Removed old rusted screws, removed old drip bowls, removed seals from old drip bowls carefully cleaned seals and replaced them on the new drip bowls. I re-installed the new drip bowls with new stainless steel screws. ( be careful not to tighten the screws to tight )
Was this instruction helpful to you?
Thank you for voting!