Models > DGRSC364CB

DGRSC364CB Dynasty Cooktop

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for DGRSC364CB

Viewing 4 of 4
Keep searches simple, eg. "belt" or "pump".
Manufacturer's Number: 20000008 Helps restore luster and remove streaks from stainless steel appliances and cookware.
No Longer Available
No Longer Available
This part is used to light the oven for the bake or broil.
No Longer Available
No Longer Available
This is the burner only. The igniter is sold separately.
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available

Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Leon from San Francisco, CA
Parts Used:
70001020
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
Oven ignition switch failed
This is actually for a Dynasty (Jade) Range (but that's not an option in the selection).

The repair is very easy - after you shut power off to the stove.

1. Remove all the stove control knobs from the front panel.
2. Remove the 2 phillips head screws on either side of the front control panel.
3. Pull the fr ont panel out about 3 inches to expose the back of the switch.
4. Use a flat head screwdriver to push the retention clips down and loosen the switch from the panel.
5. Move the 5 wires connected to the switch using pliers, one by one to the new switch.
6. Push the new switch into the panel.
7. Replace the panel and controls.
8. Restore power and test.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!