Models
>
VT614803
VT614803 Campbell Hausfeld Compressor
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for VT614803
Viewing 3 of 3
Keep searches simple, eg. "belt" or "pump".
$6.51
Genuine Campbell Hausfeld replacement part, this item is sold individually. The Ferrule in this case is used on all of the compressors listed below. It is placed inside a Compression Nut of which is o...
In Stock
Order now and your part arrives by Aug 20
In Stock
Order now and your part arrives by Aug 20
$12.04
This replacement filter element is an authentic OEM item that is commonly utilized on Campbell Hausfeld air compressors. Its purpose is to filter out dust and debris from contaminating the engine with...
In Stock
Order now and your part arrives by Aug 20
This is an OEM part made for use on Campbell Hausfeld air compressors. This rubber foot attaches to the bottom of the tank. It does not need special tools to repair. Simply slide onto the tank's bar. ...
No Longer Available
Special Order
$7.19
This part is an OEM from Campbell Hausfeld. The axle bolt is compatible with many air compressors, and is sold individually. The metal bolt fastens the wheel to the base of the tank, providing movemen...
Special Order
In Stock
Order now and your part arrives by Aug 20
$14.42
This is an authentic manufacturer sourced replacement part which is specially designed for use with Campbell Hausfeld Air Compressors. The purpose of the oil seal is to prevent oil from leaking betwee...
In Stock
Order now and your part arrives by Aug 20
$6.51
It is a genuine replacement part that is supplied directly from the original equipment manufacturer, it is specially designed for use with Campbell Hausfeld air compressors. For the correct location a...
Special Order
$11.51
This is an authentic Campbell Hausfeld replacement part manufactured for use with air compressors. The filter gasket is used to for a seal at the connection between the air filter and cylinder head. I...
Special Order
$9.87
This manufacturer sourced part is designed for use with Campbell Hausfeld air compressors. It an identical replacement for a missing or a faulty 1/4 inch set screw that was installed on a new unit. Th...
In Stock
Order now and your part arrives by Aug 20
In Stock
Order now and your part arrives by Aug 20
Common Problems and Symptoms for VT614803
Viewing 1 of 1
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Francis from CROWN POINT, NY
- Parts Used:
- ST021600AV
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set, Wrench (Adjustable), Wrench set
seal on the crankshaft was leaking oil
Removed the guard and belt. Heated the flywheel with a propane torch. Careful not to over heat it. Flywheel came off easily with a 3 point puller. Removed the cap and pulled the old seal out. Cleaned the bore in the cap to get all the oil out and dried it. Started the seal into the cap with the letters out. Carefully pushed the seal down
... Read more
into the bottom of the cap with a long socket slightly smaller than the bore. Put a little oil on the inside of the seal and put the cap back on. Reheated the flywheel somewhat again and tapped it back on the shaft with a brass drift. Put the belt and guard back on. Started the compressor. No more oil leaking around the shaft.
Read less
Was this instruction helpful to you?
Thank you for voting!