Models
>
VT232605
VT232605 Campbell Hausfeld Compressor
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for VT232605
Viewing 2 of 2
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Aug 20
$12.04
This replacement filter element is an authentic OEM item that is commonly utilized on Campbell Hausfeld air compressors. Its purpose is to filter out dust and debris from contaminating the engine with...
In Stock
Order now and your part arrives by Aug 20
Special Order
In Stock
Order now and your part arrives by Aug 20
$14.42
This is an authentic manufacturer sourced replacement part which is specially designed for use with Campbell Hausfeld Air Compressors. The purpose of the oil seal is to prevent oil from leaking betwee...
In Stock
Order now and your part arrives by Aug 20
$11.51
This is an authentic Campbell Hausfeld replacement part manufactured for use with air compressors. The filter gasket is used to for a seal at the connection between the air filter and cylinder head. I...
Special Order
In Stock
Order now and your part arrives by Aug 20
Special Order
$130.48
This is an OEM part sourced directly from the manufacturer. The valve kit is commonly found in air compressors from Campbell Hausfeld. This kit includes two valve limiters, six flapper valves, and 1...
In Stock
Order now and your part arrives by Aug 20
Special Order
$3.25
This is an authentic Campbell Hausfeld replacement part, sourced from the original manufacturer for use with air compressors. The special set screw is commonly used to secure the pump's flywheel. This...
Special Order
Special Order
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Francis from CROWN POINT, NY
- Parts Used:
- ST021600AV
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set, Wrench (Adjustable), Wrench set
seal on the crankshaft was leaking oil
Removed the guard and belt. Heated the flywheel with a propane torch. Careful not to over heat it. Flywheel came off easily with a 3 point puller. Removed the cap and pulled the old seal out. Cleaned the bore in the cap to get all the oil out and dried it. Started the seal into the cap with the letters out. Carefully pushed the seal down
... Read more
into the bottom of the cap with a long socket slightly smaller than the bore. Put a little oil on the inside of the seal and put the cap back on. Reheated the flywheel somewhat again and tapped it back on the shaft with a brass drift. Put the belt and guard back on. Started the compressor. No more oil leaking around the shaft.
Read less
Was this instruction helpful to you?
Thank you for voting!