Models > VT617203AJ

VT617203AJ Campbell Hausfeld Compressor

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for VT617203AJ

Viewing 3 of 3
Keep searches simple, eg. "belt" or "pump".
$6.51
Genuine Campbell Hausfeld replacement part, this item is sold individually. The Ferrule in this case is used on all of the compressors listed below. It is placed inside a Compression Nut of which is o...
In Stock
Order now and your part arrives by May 21
Svc Compressor Pump Cw 75 X 51Mm
In Stock
Order now and your part arrives by May 21
1/4
Special Order
This replacement filter element is an authentic OEM item that is commonly utilized on Campbell Hausfeld air compressors. Its purpose is to filter out dust and debris from contaminating the engine with...
On Order
Special Order
In Stock
Order now and your part arrives by May 21
$15.91
This is an authentic manufacturer sourced replacement part which is specially designed for use with Campbell Hausfeld Air Compressors. The purpose of the oil seal is to prevent oil from leaking betwee...
In Stock
Order now and your part arrives by May 21
This is an authentic Campbell Hausfeld replacement part manufactured for use with air compressors. The filter gasket is used to for a seal at the connection between the air filter and cylinder head. I...
Special Order
In Stock
Order now and your part arrives by May 21
Special Order
This is an OEM part sourced directly from the manufacturer. The valve kit is commonly found in air compressors from Campbell Hausfeld. This kit includes two valve limiters, six flapper valves, and 1...
Special Order
In Stock
Order now and your part arrives by May 21

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for VT617203AJ

Viewing 1 of 1
Air leak
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Francis from CROWN POINT, NY
Parts Used:
ST021600AV
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set, Wrench (Adjustable), Wrench set
seal on the crankshaft was leaking oil
Removed the guard and belt. Heated the flywheel with a propane torch. Careful not to over heat it. Flywheel came off easily with a 3 point puller. Removed the cap and pulled the old seal out. Cleaned the bore in the cap to get all the oil out and dried it. Started the seal into the cap with the letters out. Carefully pushed the seal down into the bottom of the cap with a long socket slightly smaller than the bore. Put a little oil on the inside of the seal and put the cap back on. Reheated the flywheel somewhat again and tapped it back on the shaft with a brass drift. Put the belt and guard back on. Started the compressor. No more oil leaking around the shaft.
4 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!