Models
>
VS231100
VS231100 Campbell Hausfeld Compressor
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for VS231100
Viewing 1 of 1
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Apr 6
$15.91
This is an authentic manufacturer sourced replacement part which is specially designed for use with Campbell Hausfeld Air Compressors. The purpose of the oil seal is to prevent oil from leaking betwee...
In Stock
Order now and your part arrives by Apr 6
$4.15
This is an authentic Campbell Hausfeld replacement part, sourced from the original manufacturer for use with air compressors. The special set screw is commonly used to secure the pump's flywheel. This...
Special Order
Special Order
Special Order
On Order
Special Order
This is an authentic manufacturer-sourced part which is specially designed for Campbell Hausfeld air compressors. It is an identical replacement for a missing or faulty 1/4 inch plug that was original...
No Longer Available
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Francis from CROWN POINT, NY
- Parts Used:
- ST021600AV
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set, Wrench (Adjustable), Wrench set
seal on the crankshaft was leaking oil
Removed the guard and belt. Heated the flywheel with a propane torch. Careful not to over heat it. Flywheel came off easily with a 3 point puller. Removed the cap and pulled the old seal out. Cleaned the bore in the cap to get all the oil out and dried it. Started the seal into the cap with the letters out. Carefully pushed the seal down
... Read more
into the bottom of the cap with a long socket slightly smaller than the bore. Put a little oil on the inside of the seal and put the cap back on. Reheated the flywheel somewhat again and tapped it back on the shaft with a brass drift. Put the belt and guard back on. Started the compressor. No more oil leaking around the shaft.
Read less
Was this instruction helpful to you?
Thank you for voting!