919-16561 (Type 3) Black and Decker Compressor - Parts

This is a single OEM drain valve for an air compressor. A drain valve is a small device that is usually located at the bottom of the compressor air receiver. The drain valve can be opened or closed, a...

This kit is an OEM part direct from Craftsman for air compressors. This kit consists of the parts for building a piston cylinder in the compressor. It is recommended that you release air and unplug th...

O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. rnrnThere are many cause...

This is a rubber O-ring for a compressor. It creates a seal for the tube as it enters the head. This part is sourced directly from the original manufacturer, ensuring it is the correct fit. It measure...

This replacement valve plate assembly is a high quality item designed for use on Craftsman air compressors. It is a genuine manufacturer sourced item that is used to control the airflow into the cylin...

O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes f...

This is an OEM replacement part designed to fit Air Compressors. This nut is for the tube as it enters the head. It is made out of Metal and it is Sold Individually. To replace this item you would need a Wrench.

This is a genuine OEM sourced replacement part designed for use with air compressors. It is used to secure the crankcase cover to the unit. This part is made out of metal and it is sold individually. ...

This check valve is used to direct air from the cylinder to the tank, and to prevent air from going back into the pump. It is a genuine OEM part used on air compressors. It features threaded fittings ...

This assembly fastener is supplied directly from the original equipment manufacturer. The screws are constructed of metal, and are compatible with many compressor machines. This part is often used to ...

This item has been OEM sourced to ensure a high level of quality. The gauge is intended to be used with air compressors from DeWalt. This part attaches to the regulator manifold and is used to indicat...

It is an OEM component which is designed for use with air compressors. This special nut sleeve assembly secures the pressure relief tube to the pressure switch. It is a high-quality replacement for a ...