Models
>
KPCG100OB1
KPCG100OB1 KitchenAid Coffee Grinder
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for KPCG100OB1
Viewing 3 of 3
Manuals & Guides for KPCG100OB1
Click to downloadKeep searches simple, eg. "belt" or "pump".
In Stock
On Order
In Stock
In Stock
Special Order
Special Order
Special Order
Special Order
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for KPCG100OB1
Viewing 1 of 1
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Scott from SAN DIEGO, CA
- Parts Used:
- W11109860
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Grinder burrs old & dull
I didn't do the repair. My grinder is 12 years old and I have probably ground more than 3,000 pounds of coffee through it over the years. It is a good idea to replace grinding burrs every few years to maintain grind consistency. When I pulled the old burns out and compared them to the ones I just bought I was shocked. The 'new' ones looke
... Read more
d more worn than the ones I've had for 12 years. More so, the burrs looked like they were made from cast metal, not cut from stainless steel. And they were poorly cast at that as there was pits in them. I used a 10x jeweler's loop to inspect the burrs & after inspection decided not to replace my worn burrs with a duller set. I'd like a refund, please.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mike from Coatesville, PA
- Parts Used:
- 4176695
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Safety guard broke and clogged feed port.
Removed plastic guard on underside of grinder.
Loosened two screws holding guard from underneath.
Replaced guard and replaced screws.
use tape on screws to hold while lining up blind.
Loosened two screws holding guard from underneath.
Replaced guard and replaced screws.
use tape on screws to hold while lining up blind.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- MARY-ANN M from NORTH CAOE MAY, NJ
- Parts Used:
- 4176718
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Grind selector knob was smashed into pieces during shipment
All I had to do was remove the retainer screw with the allen wrench then put the knob in place and replace the retainer screw with the allen wrench. It took me longer to locate my allen wrench in my toolkit than to make the repair.
Was this instruction helpful to you?
Thank you for voting!