5600DW Makita Circular Saw

Genuine Makita replacement part, this item is sold individually. This Retaining Ring is used in a number of Makita Tools as shown below. Retaining rings are used in various parts of tools. They are us...

This genuine OEM steel ball is found within the housing of your power tool. It serves as a detent mechanism, securing the shift knob in various positions to allow for the selection of different operat...

This is a genuine OEM replacement part designed for use with Makita power tools. This is standard hardware which has multiple applications based on your tool. Please refer to diagrams for proper appli...

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutter...

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out ...

This is a genuine manufacturer approved replacement part. It is specially designed for Makita power tools. This screw is a standard hardware which has multiple used depending on a tool. Please refer t...

This item has been sourced from the original manufacturer to be used with circular saws from Makita. The metal edge guide attaches to the saws foot or base assembly. The guide is used to measure the d...

This is a genuine OEM sourced replacement screw that is specially produced for Makita power tools. It has multiple uses depending on the tool, please make sure to check your equipments diagrams for co...

This genuine item is supplied by the original equipment manufacturer for use with Makita saws. The metal screw attaches to the rubber sleeve. When replacing this part a phillips screwdriver will be re...

This is an authentic OEM part. The rubber sleeve 6 is designed for use with many circular saws. This component assists with securing the blade case, and is sold individually. You will need a Phillips ...

This is an original replacement part manufactured for use with Makita routers and circular saws. The special spanner wrench is used to tighten and loosen the collet nut or blade nut. This spanner wren...