4200NH Makita Circular Saw

The carbon brush is used on a variety of tools and are commonly replaced because they wear out easily with time and use. If your brush is worn out it can affect the motor from working properly and red...

This cord is a genuine Makita replacement part and is sold individually. This cord is made for the double insulated tools shown below It is a two wire cord with two prongs and does not need a ground wire.

This is a self-tapping screw, and it is found on multiple power tools and lawn equipment. This screw is different because it can tap its own hole into tough materials, such as metals and hard plastics...

Genuine Makita replacement part, this item is sold individually. This Retaining Ring is used in a number of Makita Tools as shown below. Retaining rings are used in various parts of tools. They are us...

Included in Part Number 516306-1. rnThis Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating par...

This is a Genuine OEM replacement part used on Makita Power Tools. This item is made out of Plastic and it is Sold Individually. The purpose of the Brush Cap is to retain the Brushes in the Brush Hold...

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it ha...

This is an authentic OEM approved replacement item commonly used on Makita power tools. Bearings have many useful applications that will differ depending on a tool. Ball bearings are designed to minim...

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutter...

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out ...

This item has been sourced from the original manufacturer to be used with circular saws from Makita. The metal edge guide attaches to the saws foot or base assembly. The guide is used to measure the d...

The retaining ring fits next to the helical gear. This is a genuine Makita part sourced directly from the manufacturer for use in saws. This part is priced individually and is made of metal. A screwdr...