Models
>
358351182
358351182 Poulan Chainsaw
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
$6.62
This chainsaw fuel line kit carries fuel from the tank into the carburetor and from the primer bulb to the fuel system. This part is mostly used on gas trimmers and blowers. The fuel lines are made fr...
In Stock
$6.21
This is a tank purge line, also known as a fuel line kit, and it is used with various lawn equipment. The line connects fuel from the tank into the carburetor, and from the primer bulb back into the f...
In Stock
$6.21
This part is the replacement fuel cap assembly for your chainsaw. It is made of black plastic and is sold individually. The fuel cap prevents fuel from spilling out of the chainsaw and prevents debris...
In Stock
$8.71
This is a single OEM purge bulb, also sometimes referred to as a primer bulb. It is usually located close to the starter rope. By pressing down on the purge bulb, this forces fuel into the fuel line f...
In Stock
$4.99
This is a foam air filter for small engines, used in various types of outdoor lawn and garden equipment. This genuinely sourced air filter is sold individually. This is a very important part to add to...
In Stock
In Stock
In Stock
In Stock
$7.46
This is a 3ft rope for a variety of power tools, most commonly chainsaws. It twists around the pulley of the recoil starter, which will allow you to pull-start the engine. This part is made of a durab...
In Stock
In Stock
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for 358351182
Viewing 2 of 2Will Not Start
Fixed by these parts
How to fix it
Engine stops after a few seconds or minutes
Fixed by these parts
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Danny from STEVENSON, WA
- Parts Used:
- 545160401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers, Socket set, Wrench (Adjustable)
I broke the original ring
Took chainsaw apart and replaced the ring.
Was this instruction helpful to you?
Thank you for voting!
Broken piston ring and tune up
Straight forward, trick for the piston ring was to cut a soda can to make a sleeve that could be wrapped around the piston ring. A bit of duct tape with a tab held it shut until the piston was in position then it was easily removed as the piston was slid in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marvin from KIRBYVILLE, TX
- Parts Used:
- 545160401
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers, Wrench (Adjustable)
My neighbor brought the saw to me. It was locked up
He didn't want to spend alot of money on it. So I got the jug (Head) off and sanded it and the piston down while I waited on the new piston ring to get here. I found that it was easier putting the new ring in and the piston back into the jug (Head) was to go ahead and take the piston out so you could turn the jug (Head) upside down and it
... Read more
slid right in. It didn't take no time at all. And it now runs as good as new
Read less
Was this instruction helpful to you?
Thank you for voting!