Models
>
11620691
11620691 Kenmore Canister Vacuum
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for 11620691
Viewing 2 of 2Keep searches simple, eg. "belt" or "pump".
$53.61
This spark ignition valve switch is an inch and a half long. It is a white switch with a black cam. Sold individually.
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for 11620691
Viewing 1 of 1Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Max from Plano, TX
- Parts Used:
- WPY704512
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
The right rear burner ignition switch malfunctioned.
Repair is simple as long as you TURN OFF THE CIRCUIT BREAKER first. After that, take off the cover over the switches (pull knobs off, remove 2 screws and lift off the cover), pull the bad switch straight up off the gas valve, pull the two wires off the switch, plug them back onto the new switch, place it back over the gas valve stem, rea
... Read more
ssimble the cover and knobs, turn back on the circuit breaker, and verify that ignition switch works. Not a hard repair. (HINT: while you are waiting on the replacement part, you can light the bad burner by turning on the opposite burner ignition switch and using that "spark" to light the other burner.)
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- terry from joplin, MO
- Parts Used:
- WPY704512
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Igniter stuck in on position.
removed 2 screws to access the ignitor. Discinnected the wires from the old ignitor and slid the old ignitor off. Installed the new ignitor and attached wires.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mark from Clarksburg, NJ
- Parts Used:
- WPY704512
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
One burner would not ignite (no spark)
Since the other three burners sparked, I traced the problem to the switch on the valve shaft. To replace, (after unplugging the power cord) I pulled off the knobs, removed the two screws on the valve cover (inside the downdraft vent) and pulled the switch up the shaft to remove. I transferred the spade terminals to the replacement switc
... Read more
h, oriented and installed.
Read less
Was this instruction helpful to you?
Thank you for voting!