KSB1575ES0 KitchenAid Blender - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Daniel from Geneseo, NY
- Parts Used:
- WPW10279256
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The driver (coupling) on my Kitchenaid Blender disintegrated.
I decided to see if I could dislodge the faulty coupling. I placed a screw driver under the coupling and pushed up. It dislodged. Subsequently I found a youtube video that indicated that was exactly what I should do.
I ordered the part from parts select and placed the coupling on my blender. It screws in counterclockwise. It works fine. I am very satisfied.
I ordered the part from parts select and placed the coupling on my blender. It screws in counterclockwise. It works fine. I am very satisfied.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Antonio from ROSEDALE, NY
- Parts Used:
- WPW10514321
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Broken Ice Marker
Very simple I turn off the Refrigerator and disconnect the bad ice maker, removed the part. I connect the replacement parts and voila the ice maker been making ice same that day.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from MOUNT MORRIS, MI
- Parts Used:
- WPW10279256
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Timer went out would just run and run
Replaced the timer
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- shelley from Homer, AK
- Parts Used:
- WPW10279256
- Difficulty Level:
- Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Pliers, Screw drivers
coupling got chewed up
to replace the coupling you take the bottom off the blender and loosen the screws that hold the bracket and fan -then comes the hard part-the shaft screw is bolted through every bit of the guts then into the coupling. It is a lefthand thread. I ended up having to fabricate a piece of metal that slipped into the top of the coupling (in the teeth.) Then I secured the metal piece-it was just a twi inch piece of steel- in the vise, I held the blender and I got a big guy to attack the shaft bolt with a bunch of pressure and a straight screwdriver. It finally popped and I was able to unscrew the old coupling and replace it with the new. Reminds of when guys put on lug nuts and I have to try and get them off. But I saved at least $100.
Was this instruction helpful to you?
Thank you for voting!