40320 Dynabrade Bandfile

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and c...

This is a spring for your sander. It is known as a conical spring because it is cone shaped, and coiled. It is comparable to a compression spring because it stores energy by absorbing shock, and then ...

These blades in your die grinders are located on the rotor within the motor housing. This OEM set includes four blades, each measuring approximately 1-1/2 inches by 3/8 inches. When the tool is turned...

This is a genuine OEM part. The Dynabrade tip valve is manufactured for use with orbital sanders, finishers and grinders. This metal and plastic valve often sits in the air inlet bushing, and is suppo...

This knob is an original part from Dynabrade and is used as a securing mechanism in the equipment listed below. This part consists of a plastic knob with a metal threaded shaft. Please make sure to ch...

This is an original part assembled by the original manufacturer. It is compatible with various Dynabrade handheld power tools, such as grinders and finishers. Ball bearings are used to buffer between ...

This replacement o-ring is an original Dynabrade part that is specially produced for use with sanders, drills and grinders. It is an authentic OEM item that has multiple uses depending on your equipme...

This genuine Dynabrade part is OEM. It fits power tools including sanders, grinders, and various others. Bearings buffer moving parts by providing rotational support and securing position. These high ...

This authentic Dynabrade part is supplied by the original manufacturer for use with abrasive belt tools. It is utilized to support and guide the belt. If the part is missing or is damaged, this will p...

This is an authentic Dynabrade replacement part. This special metal motor lock has various applications, please see model diagram for uses, or for location on tool. The motor lock sometimes requires a...

This part has been OEM sourced and is intended to be used with buffers, sanders, right angle reciprocating filers, and die grinders from Dynabrade. The metal lever assembly includes the safety lock an...

This is an authentic OEM part. The metal screw is made for use with several abrasive belt tools. The screw secures the belt guard, and is sold individually. A Phillips screwdriver is needed for the installation.