PDA100D Hitachi Angle Grinder

This is a set of two OEM carbon brushes with the wire leads and brush springs attached. Brushes are most commonly replaced because of general wear and tear, which is perfectly normal for this part. In...

This is a genuine Hitachi replacement part. The set plate is designed by the manufacturer for use in grinders. This part is made of metal, and is used to secure the wheel guard assembly to the machi...

This authentic OEM sourced component is specially made for use with Hitachi grinders. The woodruff key is used to link a shaft and pulley or gear to allow the either the pulley or gear to rotate along...

This is an original replacement part sourced directly from the manufacturer. The side wrench is commonly used with Hitachi grinders. This part is made of metal, and is included with the machine to a...

Genuine Manufacturer Sourced replacement part used on Hitachi Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts....

This is a special component which helps to provide a tight fit between connected parts. Over time it may wear out, get damaged or lost eventually requiring a replacement. Check the appropriate diagram...

This is a pack of 10 washers which are genuine OEM replacement parts. They are used in many different tools made by Hitachi. These washers are designed to make sure that the nut does not come unscrewe...