Models > MMO219

MMO219 Amana Microwave

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for MMO219

Viewing 6 of 6
Keep searches simple, eg. "belt" or "pump".
This is a ceramic fuse for a microwave. It is just over 1 inch long. This fuse is 20 amps and 250 volts. This part powers your microwave. If your appliance is not heating properly, or is not turning o...
In Stock
Order now and your part arrives by Jun 5
$18.88
This part is also known as a rectifier.
In Stock
Order now and your part arrives by Jun 5
Special Order
No Longer Available
Nut
$7.60
Sold individually.
Special Order
$17.44
Special Order
This part is used to generate microwave energy/heat.
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available
No Longer Available

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for MMO219

Viewing 2 of 2
Won’t turn on
Fixed by these parts
Fixing
How to fix it
No heat
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Jay from Edwardsville, IL
Parts Used:
WPM0805101, D8547912
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Blows main fuse when the microwave generator start, (cooking function).
Remove microwave from oven cabinet. remove cover and check main fuse with ohm meter.
Tried fuse, it does not blow untill cooking starts.
Check capacitor with ohm meter, after properly performing capacitor dischagre procedure.
Order new capacitor, simple installation. another new fuse and all is good and cooking again.
39 of 48 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
tad from tamarack, MN
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
microwave oven blew fuse
First I removed upper front grill by removing two Philips head screws on top and pulling off. This exposed the Philips head screw which holds control panel in place. After removing screw I pushed up on panel and it came off to expose fuse. With needle nose pliers I removed old fuse and again with pliers held new fuse in position. With th e help of a bladed screwdriver, I pushed new fuse into holder, then replaced panel, screw and grill. This took less than 15 minutes even as one of the wires on control panel pulled out of connection and took some time to locate where to reconnect, otherwise was an easy fix
.
27 of 43 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Denice from Montgomery, AL
Parts Used:
WPM0805101
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
microve stopped working
Jenn-Air Microwave would not turn on. Clock worked , light worked, timer worked and would count down .I changed' Part #0813140 Switch, Micr} cost $8.99 plus shippingNow it works Thank You for good advise
15 of 30 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!