Models > AC2904XM0 > Instructions

AC2904XM0 Whirlpool Air Conditioner - Instructions

Jump to:

All Instructions for the AC2904XM0
1 - 4 of 4
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
John from Burton, OH
Parts Used:
950521
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
switch shaft was broken.
ordered new part, removed old unit, noted where wires connect, installed new one, done.
22 of 26 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Dena from Coral Gables, FL
Parts Used:
950521
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
screw holes didn't line up
I received the part the very next day which was awesome, but when I went to install it, there was a connection discrepency on the back of the switch, and the screw holes were completely off in the front where it connects to the unit. I ended up taking the whole thing apart to try to put the old face with the right screw holes on the new part and ruined it.
7 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
susan from Socorro, NM
Parts Used:
WPY015825
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Both motor clips broken - >40 year old dryer!!
Removed the back - Saw the broken clips on the base of the dryer (the wires to the motor were pulling out because the motor was slipping).

Guessed that the parts were motor clips (no pix in the web site!)

Got the parts in post - they were identical except needed some rubber grips inside to hold tight (Used pieces of bike tire inner tube cut to fit for this.) Attached clips. Works fine!!

(Son is an engineer - he found the problem. Husband is a retired doctor - he couldn't!! but together they
supplied the muscle)
Sue (67 years old)
1 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
RICHARD from SAN ANTONIO, TX
Parts Used:
485760
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers, Wrench set
No Control Of Temp.
The part was easy to remove and replace. Instructions were easy to understand. Once removed and replaced. The a/c worked great. I could control the temp and not be freezing all the time.
23 of 157 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the AC2904XM0
1 - 4 of 4