Models
>
LW1216E
LW1216E LG Air Conditioner
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for LW1216E
Viewing 1 of 1
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Mar 27
The installation kit contains the hardware you need to install the room air conditioner.
In Stock
Order now and your part arrives by Mar 27
$61.55
The condenser fan blade fits onto the air conditioner motor shaft. The fan blade helps circulate air over the condenser to cool the refrigerant before it enters in to the evaporator. This part is beig...
On Order
In Stock
Order now and your part arrives by Mar 27
$8.70
The fan blade clamp, also known as a clamp spring, are for air conditioners. The clamp supports the fan blade on the motor shaft. When the motor is running, it signals the shaft to turn and rotate, bu...
Special Order
In Stock
Order now and your part arrives by Mar 27
In Stock
Order now and your part arrives by Mar 27
In Stock
Order now and your part arrives by Mar 27
In Stock
Order now and your part arrives by Mar 27
In Stock
Order now and your part arrives by Mar 27
In Stock
Order now and your part arrives by Mar 27
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Philip from NEW MARKET, VA
- Parts Used:
- EBR77730501
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
compressor staying on, even in OFF mode: failed compressor relay on Printed Circuit Board #EBR895407
PC Board #EBR895407 No Longer Available, replaced with #EBR7773051 - mirror image board, but wires long enough and connections same.
Unit unplugged: slide filter up and out. Remove two phillips screws behind where top of filter was to remove grill (easier done with magnetic screw driver). Remove two phillips screws, one each side, at ... Read more base of cabinet. Slide assembly out of cabinet 6-8". Remove phillips screw(s) on metal control panel housing. With needle nose, rock (2) main female spade connectors left/right until off (easier done with PC board still secured). Remove phillips screw holding plastic base of PC board. Viewing new board control connectors will simplify disconnecting the (3) control plugs. A small straight blade screwdriver can help.
Unit unplugged: slide filter up and out. Remove two phillips screws behind where top of filter was to remove grill (easier done with magnetic screw driver). Remove two phillips screws, one each side, at ... Read more base of cabinet. Slide assembly out of cabinet 6-8". Remove phillips screw(s) on metal control panel housing. With needle nose, rock (2) main female spade connectors left/right until off (easier done with PC board still secured). Remove phillips screw holding plastic base of PC board. Viewing new board control connectors will simplify disconnecting the (3) control plugs. A small straight blade screwdriver can help.
Read less
Was this instruction helpful to you?
Thank you for voting!