LW1214ER ((ASWAUSH)) LG Air Conditioner - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- John from HARLINGEN, TX
- Parts Used:
- 5900A10009E
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Broken fan axial blade
Unscrewed the unit from the exterior case pulled out the unit unscrewed the 4 screw that hold the fan shroud carefully unscrewed the coil pulled back unclipped the axial fan clip gentlyhit with rubber mallet replacement of new fan replaced clip
15 minutes best investment of 20 bucks as apposed to 400 $
15 minutes best investment of 20 bucks as apposed to 400 $
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- margaret from CARRIERE, MS
- Parts Used:
- 5900A10009E
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
window a/x unit fan broke
took apart the fan housing and replaced the fan saving me hundreds of dollars from buying a new unit
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Philip from NEW MARKET, VA
- Parts Used:
- EBR77730501
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
compressor staying on, even in OFF mode: failed compressor relay on Printed Circuit Board #EBR895407
PC Board #EBR895407 No Longer Available, replaced with #EBR7773051 - mirror image board, but wires long enough and connections same.
Unit unplugged: slide filter up and out. Remove two phillips screws behind where top of filter was to remove grill (easier done with magnetic screw driver). Remove two phillips screws, one each side, at base of cabinet. Slide assembly out of cabinet 6-8". Remove phillips screw(s) on metal control panel housing. With needle nose, rock (2) main female spade connectors left/right until off (easier done with PC board still secured). Remove phillips screw holding plastic base of PC board. Viewing new board control connectors will simplify disconnecting the (3) control plugs. A small straight blade screwdriver can help.
Unit unplugged: slide filter up and out. Remove two phillips screws behind where top of filter was to remove grill (easier done with magnetic screw driver). Remove two phillips screws, one each side, at base of cabinet. Slide assembly out of cabinet 6-8". Remove phillips screw(s) on metal control panel housing. With needle nose, rock (2) main female spade connectors left/right until off (easier done with PC board still secured). Remove phillips screw holding plastic base of PC board. Viewing new board control connectors will simplify disconnecting the (3) control plugs. A small straight blade screwdriver can help.
Was this instruction helpful to you?
Thank you for voting!