Models > 58074121300

58074121300 Kenmore Air Conditioner

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".

Diagrams for 58074121300

Viewing 5 of 5
Keep searches simple, eg. "belt" or "pump".
No Longer Available
The installation kit contains the hardware you need to install the room air conditioner.
In Stock
Order now and your part arrives by Mar 19
Special Order
In Stock
Order now and your part arrives by Mar 19
The fan blade clamp, also known as a clamp spring, are for air conditioners. The clamp supports the fan blade on the motor shaft. When the motor is running, it signals the shaft to turn and rotate, bu...
Special Order
In Stock
Order now and your part arrives by Mar 19
No Longer Available
No Longer Available
In Stock
Order now and your part arrives by Mar 19
No Longer Available
Special Order

Questions and Answers

Be the first to ask our experts a question about this part!

Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
John from HARLINGEN, TX
Parts Used:
5900A10009B
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Broken fan axial blade
Unscrewed the unit from the exterior case pulled out the unit unscrewed the 4 screw that hold the fan shroud carefully unscrewed the coil pulled back unclipped the axial fan clip gentlyhit with rubber mallet replacement of new fan replaced clip
15 minutes best investment of 20 bucks as apposed to 400 $
8 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Patricia from UPPR CHICHSTR, PA
Parts Used:
AKB73016015
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Kenmore Air Conditioner Remote Broken
No repair. Just a new remote controller assembly and it works fine.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Travis from LOUISVILLE, IL
Parts Used:
4960A20005A
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
Motor mount broke due to imbalance caused by mud dobber nests.
Pulled PTAC out of wall sleeve, unhook wire harness from control area, remove condenser shroud and motor and fan blade all at the same time. Replaced motor bracket and re-installed in reverse order.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!