Models
>
PCHK11S1W1SS
PCHK11S1W1SS General Electric Microwave
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for PCHK11S1W1SS
Viewing 3 of 3
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by Apr 2
$33.20
This waveguide cover protects the microwave’s internal components by shielding the magnetron from moisture, grease, and food splatters, helping prevent sparking and ensuring efficient heating. Made fr...
In Stock
Order now and your part arrives by Apr 2
In Stock
Order now and your part arrives by Apr 2
$53.58
This door interlock switch stops the microwave from running when the door is open. It replaces older versions and helps restore safe, reliable operation. Installation requires unplugging the appliance...
In Stock
Order now and your part arrives by Apr 2
In Stock
Order now and your part arrives by Apr 2
Special Order
In Stock
Order now and your part arrives by Apr 2
Special Order
In Stock
Order now and your part arrives by Apr 2
In Stock
Order now and your part arrives by Apr 2
Special Order
In Stock
Order now and your part arrives by Apr 2
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Problems and Symptoms for PCHK11S1W1SS
Viewing 2 of 2
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Jason from KIRKLAND, WA
- Parts Used:
- WB39X10034
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Installed waveguide
Inserted the waveguide into the slots on the side of microwave.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James A from SILVERDALE, WA
- Parts Used:
- WB26X10252
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
the cover for the tray motor was attached to the bottom cover at 6 points. they were 3mm to 4mm long.
I used small wire cutter I use in fly tying hobby. The metal was easy to cut. When cover was removed I unplugged the motor,removed it and plugged the new one in.
To replace the cover -- reverse it,place the 2 tabs on one edge into the slots that are already part of the base. On the opposite edge there is a domed shaped tab with a h ... Read more ole in center. Place the small screw that was provided back in and thighten.
Your Done
To replace the cover -- reverse it,place the 2 tabs on one edge into the slots that are already part of the base. On the opposite edge there is a domed shaped tab with a h ... Read more ole in center. Place the small screw that was provided back in and thighten.
Your Done
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Larry from Greenville, MI
- Parts Used:
- WB39X10034, WB01X10418
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Wave guide cover loose, caused short
Took off old cover, stuck new one in. Pushed two plastic nails into holes.
Was this instruction helpful to you?
Thank you for voting!