6365 - Parts

This cord protector is created to slide onto your cord and fit tightly at the end to protect the base of the cord from getting damaged. If the wires are exposed it can a be a safety hazard, so make su...

This is an OEM trigger switch with four internal terminals. The switch controls the on/off and varying speed functions. It is common for the switch of a power tool to wear and malfunction over the use...

Genuine Milwaukee replacement part. Includes 1 Carbon Brush with wire lead, brush spring and bracket attached. Two brushes are needed for the tools shown below. • Worn brushes are often the cause b...

This is a screw and it is used on a variety of power tools. This part has a slotted pan head, and needs a Torx screwdriver to tighten or loosen. The measurements of the screw are #8 in diameter, with ...

This is a genuine OEM replacement switch for the door of your microwave. When the door is closed and the switch depressed, it allows the microwave to run and the turntable to rotate. When the door ope...

This is a Genuine Manufacturer Approved replacement part designed for some Milwaukee Power Tools. This item is sold individually. Due to the use or other factors a cord can crack or get damaged otherw...

Manufacturer sourced replacement part designed for use with Milwaukee power tools. It is a standard hardware which will have multiple applications based on your tool. This part is made out of metal an...

This is a Genuine OEM replacement Protector Grommet which is used on Milwaukee Power Tools. This part is made out of Rubber and is Sold Individually. It is important to have a cord protector on your t...

This Torx screw fits a variety of lawn and gardening tools. The screw has a diameter of 8, 16 thread counts, and 5/8 inches for the length. Refer to diagram provided by the manufacturer for further in...

This bracket holds the metal or plastic flapper that closes off the exhaust duct when the fan is not running and opens when the fan turns on. If the exhaust fan on your microwave does not appear to be...

It is a genuine OEM sourced item that is designed for use with Milwaukee power tools. This special bearing allows spindle shaft to rotate freely with minimal friction, over time the rollers of the bea...