Walbro Engine Parts

Fix Number

FIX10048120

Manufacturer Part Number

K10-WB

Fix Number

FIX10044036

Manufacturer Part Number

D10-WAT

This is a genuine OEM replacement part sourced directly from Walbro. If the engine in your lawn and garden equipment is running rough, the carbonator might need to be cleaned and rebuilt. This kit is commonly used for chainsaws, trimmers, leaf blowers, and edgers. Over time the carburetor gets dirty and parts begin to wear out, instead of replacing the carburetor you can replace the gaskets and diaphragms for increased performance. The kit includes all of the gaskets and diaphragms you will need to rebuild your 2-cycle engine carburetor. When the rebuild is complete be sure to check all connections before running, and while testing ensure there is only a small amount of fuel in the tank. To complete this job you will need a screwdriver and a pick.

Fix Number

FIX9912182

Manufacturer Part Number

188-12-1

This is a genuine OEM replacement part sourced directly from Walbro. When you press the primer bulb, it forces the air out of the carburetor. As the air leaves the carburetor fresh fuel will be pumped from the tank, through the fuel line, into the carburetor. This makes it easier to start the small engine in your outdoor power equipment. This primer bulb is commonly used in edgers, leaf blowers, trimmers, pruners, and tillers. Due to constant exposure to fuel, the primer bulb will deteriorate over time; it may lose elasticity or crack, it will then need to be replaced. The primer bulb is easy to access and replace, you will need a screwdriver to complete the job.

Fix Number

FIX10018099

Manufacturer Part Number

86-578-1

Fix Number

FIX10048145

Manufacturer Part Number

K20-WAT

This is a genuine OEM replacement part sourced directly from the manufacturer. The carburetor is responsible for regulating the amount of fuel and air that make it to the engine; this ensures the fuel is burning properly in your outdoor power equipment. Over time the carburetor gets dirty and parts begin to wear out, instead of replacing the carburetor you can clean and rebuild the one you have. This kit gives you all the parts you need to do that job, and is commonly used to rebuild carburetors found in trimmers, tillers, and edgers. Signs your carburetor could be clogged or dirty are that the engine is not running properly, it is not running at all, it will not stay running, it is difficult to start, or if it emits a lot of smoke. In order to successfully rebuild your carburetor we suggest that as you disassemble the old carburetor pay attention to the order and placement of the parts you are removing, when reassembling reverse the removal order. When you are finished rebuilding the carburetor be sure to inspect all connections before running. Place only a small amount of fuel in the tank while testing the new carburetor. To complete this job you will need a screwdriver and a pick.

Fix Number

FIX10048155

Manufacturer Part Number

K22-HDA

Fix Number

FIX10048122

Manufacturer Part Number

K10-WJ

Fix Number

FIX9912187

Manufacturer Part Number

188-17-1

★★★★★

★★★★★

1 Review

Fix Number

FIX10048112

Manufacturer Part Number

K1-WHG

Fix Number

FIX10034285

Manufacturer Part Number

95-526-9-8

This is a genuine Walbro replacement part. The metering side of your carburetor is a self adjusting vacuum based system, the diaphragm moves depending on the amount of fuel being pulled into the motor. At higher speeds more fuel is being pulled into the engine, the diaphragm compresses and the pin in the center of the diaphragm pushes on the metering lever, which lifts the regulator inlet needle and allows more fuel to travel from the pump into the reservoir. This is why it is important to ensure your metering diaphragm is in good shape, it is a very important part of the fuel regulator assembly on your carburetor, which ensures your engine is getting the appropriate amount of fuel to run smoothly.