This is a drain pump motor assembly for washers. This OEM part is responsible for removing water from the washer during the drain part of the cycle. When this part is clogged, damaged or defective it can cause the washer to not drain properly. Keep in mind that the pump casing is sold separately. This repair is rated medium-difficulty and can vary depending on the model. For this repair you will need a Philips screwdriver, a small flat blade screwdriver, needle nose pliers, and slip joint pliers. Do not forget to disconnect the power before you begin this repair. In general, this repair can be started by removing the top of the washer followed by the front panel. Moving down the front of the appliance, remove the door, latch, tub gasket, and drainer cover. The drain hoses and clip will need to be disconnected from under the drain assembly. To install the new pump motor, reassemble parts in the reverse order. We recommend taking photos while disassembling and keeping screws and parts neatly organized.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
2 people found this helpful.
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
