FUNNEL SHOWER HEAD Assembly

TURN OF POWER AND WATER TO THE UNIT.1) Put putty knife about six inches from left and push to release clip holding the front to the top. Repeat on right hand side and release clip. 2) Front panel comes out. 3) Remove two screws holding top of washer and lift up top carefully. Top will not come up all the way until you remove sensor by gently prying it out of top using a screw driver. 4) On the under side of the top, shower head funnel is visible. Remove two screws to get it out. Carefully pry out a sensor that is in the shower head assembly. 5) Remove three screws in the rear and you will see the showerhead hose connecting to the mixing valve. Undo the hose clamp and slide out the old showerhead. Install the hose of the new showerhead on the mixing valve. 7) Return to the front and install the new showerhead first by putting in the sensor in the hole in the middle and then securely installing and tightening the two screws. 8) Reinstall the rear panel and the top of the washer including the sensor in the top and tightening the two screws. Reinstall the front panel by making sure it catches on tabs in the front push so it clicks in place. MAKE SURE ALL YOUR WORK IS SAFE AND ALL THE WATER HAS BEEN DRIED OF. I AM A LAYMAN AND THESE INSTRUCTIONS ARE PROVIDED AS A COURTESY. YOU ARE SOLELY RESPONSIBLE FOR YOUR WORK. Turn on power and water and check for leaks.