Capacitor

Bought Capacitor, but I had to purchase Combo Start Up Kit that Cap goes into. The site said that 78% of the time my problem of both compartments being warm were resolved/repair by replacing Capacitor, but when the item was replaced it did not and my son looked further and found that it would then be the Combination Start Up Kit (Part# PS11740412), which starts the compressor. Thanks to this site the video used to install both parts. I was able to use the old Capacitor and I am returning the new one first purchased.

We were hearing a clicking noise coming from our refrigerator/freezer combo. The freezer wasn’t defrosting correctly. I pulled the unit out, unplugged the refrigerator, pulled off the flimsy cardboard backing. I pulled off the old unit (compressor start relay/capacitor) unplugged it from the wiring harness, hooked up the new components to the unit and plugged it into to the compressor (three pins, only one way to put it on correctly) and put the cover back on. I plugged the unit back in and pushed it back into place and it has been working like a champ for a couple of weeks now

According to everything I read, if the compressor wouldn't start then it's either a bad compressor ($365 for new compressor + $400 labor + $79 trip charge for technician to fix it) or it was a bad capacitor and/or start-dev (relay +overload circuit). For about $80 for the capacitor and start-dev I was willing to try these parts out and just skip having a technician come out. (If this didn't work, I would be going to buy a new refrigerator. I will say that this repair tactic wouldn't have been very doable if we didn't have a extra fridge in the garage so that could wait for the parts to be delivered. The repair was successful and it took about 15 minutes to complete the repair. Steps: 1) Pulled the fridge away from the wall and unplugged it. 2) Used my nut driver to remove the access panel at the bottom rear of the fridge. 3) The 'start-dev is pushed onto 3 pins on the side of the compressor. The capacitor is pushed onto 2 pins on the outside of the start-dev. Both can be removed together from the side of the compressor.4) Once removed, then disconnect the electrical 'molex' connector from the start-dev. Lift the tab on the side, and wiggle it off. 5) reverse these instruction to install the new parts. 6) After plugging in the fridge, the compressor should now come on and stay on while it cools your food down.

Ordered the parts and the arrived the next day as promised. Removed the back panel to the fridge, the compressor was right inside the opening. removed a clip and unplugged the compressor start device. removed the old parts that were bad and installed new ones. plugged everything back and the plugged in the fridge and it started right up.

I'm not a repairman, but fairly handy, so I looked around on the net, and saw the problem was probably the capacitor or the combo start device. Found a video on this site that was very clear. I ordered both parts just to be safe. Got 'em within a week and did the installation as described on the video(s). Super easy. She fired right up and is cooling as well as before! $95 for the parts and shipping saved a refrigerator freezer no longer made! Thank you!

Discovered that I had a bad overload relay and fridge would not cool. Verified that I did have power to the compressor. After removing the assembly from the compressor. I found a rattle sound in the relay and disassembled the part , finding my deduction was correct. I went on line and found a compressor start kit and capicitor which was correct for my fridge. These parts came to $75.00 delivered. I thought that this is cheaper than a new compressor of $600.00 plus installation or a new fridge. So I ordered the kit and installed it in under 30 minutes. My fridge is up and running saving me a lot of money for costly repairs or a new fridge. Worked out fantastic allowing me to used the saved money elsewhere . Great site will continue to use this site in future repairs. Thanks

pulled back cover off. unpluged freezer.unpluged wiring harness.pulled capacitor off.reverse proceedure to install.freezer cooling now.

Installation of capacitor did not fix problem
Installation of thermistor did not fix problem
Will not be spending any more time or money on this as
that is a rabbit hole down which money will flow abundantly.

The part you said would fix it 99 % of the didn't fix it I had to go to my local appliance store and get the part that fixed it

I did the repair exactly like the video showed. The instructions were step by step and it was super easy to do. Even with overnight shipping, we only spent $108 to fix the refrigerator. We figured we would spend at least that much just to have someone come and look at it and it sure beats buying a new $1400 refrigerator! I would recommend this site to everyone!!