Ice Chute Door Return Spring

New spring and door strike replaced as a precautionary measure d/t the age of the appliance. Was already paying the shipping cost of the door.

I followed the lead of the professional video provided so will not go into details on what I did. I'll just add a few of my hurdles that I ran into. Pay close attention to the video on how the solenoid stem fits onto the plastic assembly. I didn't get that exactly correct the 1st time around and first try didn't go well. I also ha ... Read more d a problem with the 'CUBE' option being selected after reassembly. I had to clean the contacts up on the printed circuit board. I used an eraser which didn't seem to work. Then used a small screwdriver to remove a small film off from the contacts. Finally got the cube selection to work. I believe these new parts will also help in preventing the dispenser from frosting up. Won't know for sure until summer time but when its humid out our ice assembly would frost up often. The new ice shute flapper seems to seal much better than the old one because the seal had practically worn away on the old one. Again, watch the professional video. It is an exact representation of what needs to be done.

I watched the video (twice). Then followed the steps shown in the video and it was easy. I ordered the Ice door return spring but did not use as the original was intact. Likewise, I did not have to use the solenoid. The original is still working.