Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
November 8, 2021
Will this fit the Kenmore Elite
For model number 795.75196400
Hello Mike, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is Fix Number: FIX3536013. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!
This part is the replacement water line or tube for your refrigerator. It is made of white plastic and is sold individually. This tube supplies water to the ice maker and water dispenser If your refrigerator is leaking, ...
Tubing for incoming water for ice maker and dispenser leaking.
The original tubing from LG was cut exactly to fit. Had to remove the water filter inside the refrigerator. It was just one screw, so it came off very easily. The tubing connected to the filter at the rear with a quick disconnect. Very easy swap out. The tubing is also connected to the pump (located at the bottom of the refrigerator behind the cover plate. Only needed to take off 6 screws and one screw that held the pump on. The tubing was also held on to the pump with a quick disconnect as well. The tubing is secured to the rear of the refrigerator by plastic clips and screws. This replacement was extremely easy to do.
Water would spray out on the wall in the back when you pressed the water dispenser.
removed lower section at back of refrigerator for access to the solenoid valve, removed retaining clip and pressed in the retainer to release the hose, loosen hose clips on back to removed hose, removed cover at back of water filter and removed both retaining clips and pressed in retainer to removed hoses, removed filter inside of refrigerator for access of screw holding filter housing, pulled forward to removed filter housing pulling hoses through. removed hose retainer and pressed in on retainer to removed hose. fit new hose. feed both hoses through the back of refrigerator. fit filter hose ,retainer and cover on hoses, Removed spring from old hose and fit to bottom of hose and installed new hose in solenoid, fit retaining clip and then route hose through hose clips on back of refrigerator. fit cover at lower back, install new filter and bleed air out. Check for leaks.