Water Fill Cup and Bearing

Sadly, although it appears you could just snap the fill cup into the groove on the tray, this is not the case. You must remove and disassemble the ice tray assembly to replace this small part. Luckily, this is not terribly difficult. Here are the steps: 1-Remove hex-screw on bottom of ice tray assembly, and loosen two screws on top. 2-Lift assembly off top screws to remove from side of freezer. 3-Unplug power cord. 4-Unsnap front cover on front of unit. 5-Remove ice make motor by removing the screws on front of the unit. 6-Remove Motor Housing by removing the tow recessed screws toward the bottom. 7-Now the ejector arm should be free. Slide it forward from the groove in the ice tray. 8-Remove old fill cup from ejector arm, and slide new fill cup onto it. 9-Reassemble ice tray assembly reversing the steps above.