GE/GE_Thumb/00119164i06.gif
See part 615 in the diagram
( Grid squares measure 1x1 inch )

Evaporator/Condensor Fan Grommet

$ 6.25   In Stock
Fix Number: FIX284555
Manufacturer #: WR02X10098
Manufactured by: GE

Product Description

This evaporator fan motor grommet, or condenser fan grommet is built for refrigerators. It provides a cushion between the fan motor and the motor mounting bracket. It is made or round, black plastic and is approximately one inch in diameter. If your grommet is torn or damaged and you are getting noise from the fan motor, you may need to replace it. This is an OEM part sourced directly from the manufacturer.

Installation Instructions Provided by Fix customers like you.

Average Repair Rating: 3.4 / 5.0, 3 reviews.
    Sort by:
    Sorry, we couldn't find any existing installation instruction that matched.
    • Customer:
      Scott from Nampa, ID
    • Parts Used:
      WR60X10220, WR02X10098
    • Difficulty Level:
      Really Easy
    • Total Repair Time:
      15 - 30 mins
    • Tools:
      Nutdriver
    Fan was rubbing against fan shroud and running slow. Rubber gromets were worn and allowing fan motor to sag.
    Unplugged the refrigerator. Pulled rear access plate off (removed 7 screws). Disconnected fan motor. Fan motor was running slow even if the fan propeller was clear of fan shroud. Removed two screws to remove the fan motor from mounting bracket. With fan motor loose, I removed the fan propeller from motor by pulling it off the shaft. I then slid the motor shaft out from the mounting bracket to remove fan motor. I then vacuumed out the condenser coil area to remove dust. I cleaned the fan propeller. Removed rubber grommets from motor mounting brackets and replaced them with new ones. Slid new fan motor shaft through mounting bracket and maneuvered motor so as to attach the fan propeller. Reattached fan propeller by pushing it back onto the motor shaft. Fitted motor into the mounting bracket and secured to coil housing with the two screws I removed earlier. Make certain that the grounding wire is secured under one of the mounting bracket screws. Plugged the refrigerator back in. Observed that the fan was rotating free and clear of fan shroud. Reattached the rear access plate.
    2 of 2 people found this instruction helpful.
    Was this instruction helpful to you?
    Thank you for voting!
    • Customer:
      Michael from Asheboro, NC
    • Parts Used:
      WR60X10170, WR02X10098
    • Difficulty Level:
      Easy
    • Total Repair Time:
      30 - 60 mins
    • Tools:
      Nutdriver
    Refrigerator was making a squeaking / squealing noise at certain times
    Researched possible cause on YouTube determining it could possibly be the condenser fan motor. Relatively easy to remove and replace after watching YouTube videos. Approximately 30 minute repair time
    1 person found this instruction helpful.
    Was this instruction helpful to you?
    Thank you for voting!
    • Customer:
      Alfred E. from Bloomfield, NJ
    • Parts Used:
      WR02X10098
    • Difficulty Level:
      A Bit Difficult
    • Total Repair Time:
      30 - 60 mins
    • Tools:
      Screw drivers, Socket set
    Loud Noise
    I watched the video that this site has online. First shut off the power by pulling off the electrical line. If I hadn't watched the video I would have replaced the fan too instead of just the two grommets. I also probably wouldn't have seen that there are 2 grommets, as one of them is kind of hidden in the back of the fan. Also, getting the clip that secures the fan off and back on is not easy. Needle nose pliers are needed and even with those it is not as easy as the video repair man accomplished it. I found expanding the round clip a little made it possible to get it back on. I also put a little Vaseline on it so it slipped back on. Be careful not to damage the fragile styrofoam when you are removing the plastic shield at the start of the project. Go slow. If you damage it, duct tape may help to repair it. You can do this job. Also don't loose or drop the screws.
    0 of 1 people found this instruction helpful.
    Was this instruction helpful to you?
    Thank you for voting!
      Model Compatibility
      This part works with the following models:
      Fix Number: FIX284555
      Manufacturer Part Number: WR02X10098
      Brand
      Model Number
      Description
      General Electric
      31181-1
      Refrigerator
      General Electric
      31191-1
      Refrigerator
      General Electric
      3210-00L0S00-A
      Refrigerator
      General Electric
      3210-00R0S00-A
      Refrigerator
      General Electric
      36211XBMBRWW
      Refrigerator
      General Electric
      36211XBMDRWW
      Refrigerator
      General Electric
      36211XBMERWW
      General Electric
      36211XBMFRWW
      General Electric
      36211XBRERWW
      General Electric
      36211XBRFRWW
      Kenmore
      36348042891
      Refrigerator
      Kenmore
      36348042892
      Refrigerator
      Kenmore
      36348042893
      Refrigerator
      Kenmore
      36348042894
      Refrigerator
      Kenmore
      36348042896
      Refrigerator
      Kenmore
      36348042897
      Refrigerator
      Kenmore
      36348047891
      Refrigerator
      Kenmore
      36348047892
      Refrigerator
      Kenmore
      36348047893
      Refrigerator
      Kenmore
      36348047894
      Refrigerator
      Kenmore
      36348047896
      Refrigerator
      Kenmore
      36348047897
      Refrigerator
      Kenmore
      36348252891
      Refrigerator
      Kenmore
      36348252892
      Refrigerator
      Kenmore
      36348252893
      Refrigerator
      Kenmore
      36348252894
      Refrigerator
      Kenmore
      36348252896
      Refrigerator
      Kenmore
      36348252897
      Refrigerator
      Kenmore
      36348257891
      Refrigerator
      Kenmore
      36348257892
      Refrigerator