OEM Milwaukee Nibbler & Shears Parts & Accessories

Carbon Brush (Sold Individually)

$4.99

Fix Number: FIX10122113
Manufacturer Part Number: 22-16-0275

This is a carbon brush, it is also known as a motor brush, and it is used with various power tools and equipment. The brush transfers electric currents to the motor. Your motor brush is an extremely common replacement part. It is considered a wear part, because the constant friction will wear it down. If you are experiencing a poor running motor, you will need to replace this part. New brushes will restore your motors electric braking. We recommend also inspecting your armature for damaging cracks or burns, this can indicate a larger problem in your motor that will require attention.

Carbon Brush/Lead (Sold Individually)

$5.89

Fix Number: FIX10122198
Manufacturer Part Number: 22-18-0710

This carbon brush lead or also known as a carbon motor brush fits the following tools: angle grinders, nibbler and shears, sander polishers, and jig saws. This includes the brush and a wire lead attached. This is one of the most commonly replaced power tool components because the carbon brushes easily wear off with friction and use. If your brush is worn out it can cause intermittent motor function, reduction in electric braking, and in motor power. If you notice burns and cracks on the wire lead, then it is best to replace this part. Tip: when replacing your carbon brush, make sure to inspect your armature for damage as well, in case there are larger motor problems.

Brush Assembly (2 Required)

$9.81

Fix Number: FIX10122258
Manufacturer Part Number: 22-18-1310

This is a single carbon brush, and it is compatible with various types of equipment. Although it is sold individually, it is always recommended to replace both carbon brushes are the same time, even if only one appears worn. Properly maintaining the carbon brushes will ensure your motor runs consistently smooth, protecting the longevity of your equipment. Take this opportunity to also inspect the armature, especially if sparks are present.

Watch the install video

Cord Protector

$4.99

Fix Number: FIX10131782
Manufacturer Part Number: 44-76-0210

This cord protector is created to slide onto your cord and fit tightly at the end to protect the base of the cord from getting damaged. If the wires are exposed it can a be a safety hazard, so make sure to replace your cord protector if damaged. Refer to the manual provided by the manufacturer for further installation instructions.

Cutting Spring

$4.99

Fix Number: FIX10127843
Manufacturer Part Number: 40-50-0585

Cord Set

$12.69

Fix Number: FIX10122674
Manufacturer Part Number: 22-64-0215

This is a cord set for your power tools. It is constructed with a tough outer-rubber insulation for a longer life span. The 18-gauge power cord is 8 feet long, and comes with 2 prongs and 2 wires. This cord is black in color and is sold individually.