Have you ever purchased from us before?
Thank you for helping make our site better.
Manufacturer #: WP9703337 /
Manufactured by: Whirlpool /
Fix #: FIX11746905
Manufacturer #: WP9703337 |
Manufactured by: Whirlpool |
Fix #: FIX11746905
followed instructional video the hardest part was removing the snap ring! once that was removed it was a piece of cake!
Were these instructions helpful?
1.Remove Mixer top (4 screws) 2.remove gear case cover (4 screws) 3. Remove old retaining ring 4. Lift old bevel gear from shaft. 5. Remove retaining pin from shaft and drop shaft out bottom 6. Remove ALL old grease making sure to get all metal pieces from old bevel gear. 7. inspect all gears for damage 8. replace shaft and retaining pin 9. Place new bevel gear onto shaft and secure with retaining ring 10 Install new grease liberally 11. replace gear cover case and secure with 4 screws 12. Replace case top and secure with 4 screws
Problem found is plastic transmission cover cracked causing too much play between gears causing them to skip and strip. New replacement cover is cast metal. Great improvement. Remove trim ring (one screw). Remove top cover (4 screws). Remove plastic transmission cover (4 screws). Remove snap ring that holds too beveled gear. Replace gear and re install snap ring. Replace gear in transmission (other beveled gear) I also replace bronze bushings at each end of the adjacent worm gear. Re pack all gears and transmission cover with fresh grease. Reinstall all gears and transmission cover. Ensure all components are properly seated and lined up. Re instal cover and trim ring. Easy fix. Less than an hour. Works as good as new. Replacement parts fit perfectly.
Took it apart. Saw the broken gear. Got online and ordered the parts and completed the repair as soon as the parts came.
If your friends and family don't all live in one place, it can be…