Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Robert
February 13, 2023
Does the impeller assembly Ry 308164004 fit the P2102 model?
For model number Ryobi blower P2102
Hello Robert, Thank you for your inquiry. Researching the model number that you have provided, we do not show this part listed, nor do we show your model in the compatible models list for this part. We strongly recommend you contact the manufacturer, as they would have this information in their system. Ask them for the part number you require and contact back to see if it is something we carry. We hope this helps.
5 people found this helpful.
Was this helpful?
Thank you for voting!
Richard
August 25, 2023
Is this the propeller for this blower
For model number Ry40401.
Hello Richard, thank you for reaching out. According to our research, the impeller assembly you mentioned is compatible with your model. Glad to be of help!
1 person found this helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Installation Instructions Provided by Fix customers like you.
Average Repair Rating: 3.3 / 5.0, 1 reviews.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
While the blower was in use, something got too close to the air inlet, and the impeller took in foreign material that damaged the impeller blades.
Turn the blower on its side, there are approximately (14) T15 Torx screws that are about 1" long that all need to be removed. Some are recessed inside further which requires a T15 driver with approximately 4" of depth to reach them. After all screws are removed, the two outer cases split apart right down the middle. The blower nozzle does need to be removed prior to separation, and also there are a few Ryobi factory stickers that will need to be sliced down the middle of them to allow the cases to separate. Once the case is removed, you will see the motor with the impeller attached. The motor can be slid out of its housing far enough to be able to remove the impeller. To remove the impeller, use an adjustable wrench of the end opposite the impeller, there are flat areas on the impeller shaft where an adjustable wrench can be tightened onto to hold it steady. With the adjustable wrench in place, the impeller can easily be removed by unscrewing it from the thread end of the shaft. Be careful because my impeller threads were reverse threaded to allow for the impeller to stay tight. I recommend using permanent strength thread lock on the threads of the shaft prior to tightening it down onto the motor shaft. Pay close attention to install the impeller in the same direction as the old one was removed. After this step, reassemble in reverse order.
6 of 6 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Model Compatibility
This part works with the following models:
Fix Number: FIX11857310
Manufacturer Part Number: 308164004