Craftsman Trimmer Carburetors

Fix Number

FIX9119300

Manufacturer Part Number

753-06190

A carburetor basically consists of an open pipe through which the air passes into the inlet manifold of the engine. The pipe is in the form of a Venturi: it narrows in section and then widens again, causing the airflow to increase in speed in the narrowest part. Below the Venturi is a butterfly valve called the throttle valve ' a rotating disc that can be turned end-on to the airflow, so as to hardly restrict the flow at all, or can be rotated so that it (almost) completely blocks the flow of air. This valve controls the flow of air through the carburetor throat and thus the quantity of air/fuel mixture the system will deliver, thereby regulating engine power and speed. The throttle is connected, usually through a cable or a mechanical linkage of rods and joints. Fuel is introduced into the air stream through small holes at the narrowest part of the Venturi and at other places where pressure will be lowered when not running on full throttle.

Fix Number

FIX9030700

Manufacturer Part Number

545081848

This carburetor rebuild kit (part number 545081848) is for lawn and garden equipment engines. Carburetor rebuild kit 545081848 includes gaskets and parts for rebuilding the carburetor. Work in a well-ventilated area and drain the fuel from the tank and fuel lines before rebuilding the carburetor

Fix Number

FIX9003852

Manufacturer Part Number

530047721

If your engine is having trouble starting, you may be in need a new purge bulb. When the engine has been sitting for a while, unused, the fuel will drain and eventually dissolve out of the carburetor. The next time you go to use your equipment, the engine will not start until the carburetor has fuel in it. The purge bulb, also commonly referred to as a primer bulb, manually pumps fuel back into the carburetor, while purging air out. If the purge bulb is malfunctioning, you will need to pull the starter rope numerous times until the carburetor diaphragm can pump the right amount of fuel back into carburetor for the engine to start. This purge bulb is prone to hardening and cracking over time because it is in continuous contact with fuel and will need to be replaced. This part is sourced directly from the manufacturer and sold individually.

Fix Number

FIX9003852

Manufacturer Part Number

530047721

This part includes one primer bulb, also known as a purge bulb. This high-quality replacement part is sourced right from the original manufacturer. When the engine of your equipment has been left unused for an extended period, the fuel will drain and evaporate out of the carburetor. To start the engine again there needs to be fuel in the carburetor. The purpose of the primer bulb is to manually pump fuel into the carburetor for an easier start. Due to its constant use and exposure to fuel it will likely crack and damage over time and will require replacing. Before you begin this repair be sure to empty the fuel from the tool.

Fix Number

FIX19283399

Manufacturer Part Number

753-06288

Fix Number

FIX11812945

Manufacturer Part Number

753-08174

This is an original replacement part sourced directly from the manufacturer. The carburetor is found in Craftsman trimmers. This part is a complete carburetor assembly made primarily of metal, and is used to mix fuel and air together for ignition in the engine. You will require a screwdriver when replacing this item. The carburetor is sold as an individual replacement part.

Fix Number

FIX16428389

Manufacturer Part Number

753-06258A

A carburetor is an important component which combines fuel and air before the combustible mixture is sent into the cylinder. Over time parts may wear out or get damaged eventually requiring a replacement. Keep in mind this high-quality carburetor is sold as an individual item. Refer to the appropriate diagrams for your model to ensure the correct repair procedure. It is a genuine OEM carburetor which is specially made for lawn and garden equipment.

Fix Number

FIX9285128

Manufacturer Part Number

530069844

This is a carburetor repair kit, but it may also be known as a carburetor gasket or diaphragm kit, for your lawn equipment. This assembly is used to replace the gaskets in your machine. If you are having problems with your carburetor, this kit most likely takes care of it. Note: The beige piece pictured has been redesigned. It no longer has the 4 corner holes. It now only has 2 corner holes at a diagonal. To replace these items, you will need a screwdriver and pliers.

Fix Number

FIX16365681

Manufacturer Part Number

545190501

This is an OEM Poulan Carburetor Intake Boot used on gas trimmers to connect carburetor to a carburetor-adapter. This part is made out of Rubber. Over time rubber material can dry out and crack. If this part is warped, cracked or damaged it needs to be replaced for the unit to operate properly.

Fix Number

FIX9004629

Manufacturer Part Number

530035596

This is an authentic Husqvarna replacement part manufactured for use with trimmers and brush cutters. The carburetor adapter is used to connect the carburetor to the cylinder. The carburetor adapter is available as an individual replacement part, please note the gaskets are available separately.