Shindaiwa Power Broom Parts

Primer Pump This is a primer pump or primer bulb, and it is used on various outdoor lawn equipment. This part has an outer diameter of 0.616 inches, it is dome shaped, and transparent. The primer pump gives the engine of your machine a faster start by pulling fuel into the carburetor. If your pump is malfunctioning your machine will not receive the fuel it needs to operate properly. If you notice the primer pump is leaking you must replace it, as it could become dangerous.

Fuel Filter

Clip 6 This clip fits lawn and gardening tools. The clip secures the fuel filter to the fuel line on the unit. *Please note: the clip is sold separately. Refer to the manual provided by the manufacturer for further installation instructions.

Gasket This gasket fits lawn and garden equipment. It provides a seal for the gas cap. With use, the seal can wear off and become compressed. In this case, it is best to replace the gasket. *Please note: this part is sold individually. No tools needed are needed to replace this gasket, simply remove the old one and place a new gasket inside the fuel cap.

Clip This is a clip for a variety of lawn and garden equipment. The clip is made of a durable metal, and is 6.5mm in diameter. This part is most commonly used to clamp tubes and hoses in place. The clip is sold individually.

Filter, Fuel This is an OEM fuel filter and is sold individually. This repair is very easy and will only take a few minutes. It is also a very important maintenance task that should be done regularly. This part is located inside the fuel tank and filters out debris to prevent it from making its way to the carburetor. If you notice fuel is leaking or their seems to be blockage, your fuel filter is likely in need of a replacement.

Washer 5 This washer fits gardening tools such as hedge trimmers, leaf blowers, chainsaws, engines, power brooms, tillers, water pumps, concrete saws, and cultivators. *Please note: this is sold individually. The washer helps spread the pressure evenly between two connected parts in your tool. For proper installation and application, check the diagram provided by the manufacturer.

Nut 5 This nut is used for a variety of handheld gardening tools. The nut has multiple applications depending on the tool you are using. Refer to the diagram provided by the manufacturer for installation instructions and nut location in a specific tool. This lock nut is used to resist loosening when threaded onto a bolt. *Please note: this part is sold individually. The measurements are: 5mm.

Pre-Filter, Foam

Filter, Air