Black and Decker Hedge Trimmer Parts

Black and Decker Appliance Parts

Popular Black and Decker Hedge Trimmer Parts

Spool Assembly
$14.92
In Stock
Fix Number
FIX17016195
Manufacturer Part Number
AF-100
Spool Assembly
Cap Assembly
$7.55
In Stock
★★★★★
★★★★★
2 Reviews
Fix Number
FIX12094047
Manufacturer Part Number
90583594N
This is a cap assembly, also known as a spool cap. It is made of durable plastic, is red in color, and sold individually. The purpose of the cap assembly is that it keeps the spool contained securely in the spool housing. It can be removed by depressing the two tabs on either side and pulling it off. While you have it removed, it is a good time to remove any dirt and grass from the spool and cap. Install your new cap assembly by aligning the tabs with the slots on the spool housing and snap the cap on by depressing the tabs and pressing it into the spool housing.
Charger
$25.43
In Stock
Fix Number
FIX12164184
Manufacturer Part Number
90640340
Genuine Manufacturer Sourced replacement part used on some Black and Decker Power Tools. This item is sold individually. Purchasing a charger will be less expensive than buying a new tool. Please note that a weak or defective battery can damage the charger. Weak batteries are batteries with bad cells. These type of batteries will not hold a charge. It will send a message to the charger to keep charging. This will eventually cause the charger to overheat and potentially smoke.
Handle
$10.69
In Stock
Fix Number
FIX17016371
Manufacturer Part Number
90517802-01
Handle
Blade & Gear
$54.26
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX12004727
Manufacturer Part Number
90640927

Installation Instructions

Gerald from NORTH BERGEN, NJ
The blade and gear were not the difficult part of this repair.
In taking aprt the body of the tool you must be careful not to disrupt or dislodge the mechanism that locks and unlocks the swiveling handle. I unknowingly did this and it took me a while to #1) figure out how it worked and, #2) to get it back together again. The blade and gear were fairly simple. It seems that you can carefully separate the halves of the handle just enough to extract the old blade and gear half of the tool. Without instructions its a little challenging. Read more...
Brush
$5.95
In Stock
Fix Number
FIX10105860
Manufacturer Part Number
089754-01

Installation Instructions

tom from TWO RIVERS, WI
motor noisey
I don't know exact cause for noise. Thought it might be brushes. Got one out; it looked ok. Repair was not possible because the second brush holder could not be removed due to interference from wiring. I would have tried to replace motor shaft bearing but part NLA. Read more...
Switch,On/Off
$5.95
In Stock
★★★★★
★★★★★
2 Reviews
Fix Number
FIX10170531
Manufacturer Part Number
383994-00

Installation Instructions

Craig from FREMONT, CA
Always on equal a safety issue.
The switch has a spring tension so that the default condition is in the off position. The trigger moves the switch to the on position when the user grips the trigger mechanism and provides an active resistance to the spring portion of the switch, enabling power to the hedge trimmer motor. There are six to seven torx T15 screws that, when removed, enables the unit to separate into equal parts, exposing the internal trigger mechanism and the switch. The replacement drops right in after removing the old switch. Re connect the electrical connectors to the new switch. Re align the the two halves and tighten the torx screws. The hedge trimmer is then good to go! Read more...
Bail Handle
$7.52
In Stock
Fix Number
FIX17016199
Manufacturer Part Number
90546340
Bail Handle
Spool Housing
$16.63
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX12004675
Manufacturer Part Number
90589746
Terminal
$5.95
In Stock
Fix Number
FIX10173367
Manufacturer Part Number
444262-00

Black and Decker Hedge Trimmer Appliance Types

Popular Black and Decker Hedge Trimmer Models