Edger Springs and Shock Absorbers

Fix Number

FIX9263507

Manufacturer Part Number

15901103432

This genuine OEM sourced replacement part is designed for use with blowers/trimmers. This is the spring for the spark plug boot. This spring is made out of metal and it is sold individually.

Fix Number

FIX11841751

Manufacturer Part Number

50018904

Genuine Worx replacement part, this part is sold individually. This spring is used in the Cutting Line Feeder Assembly to help in advancing the Cutting line. This part has a tendency to get lost when replacing the spool. It is advised to keep an extra one on hand.

Fix Number

FIX16527518

Manufacturer Part Number

P022019680

This item has been sourced from the original manufacturer and is intended to be used with trimmers, edgers, and blowers from Echo. The metal spring is part of the recoil starter assembly and is used to rewind the starter rope after it has been pulled to start the motor. This item is sold as an individual replacement part.

Fix Number

FIX9004040

Manufacturer Part Number

530016454

This is an OEM part guaranteed to fit Milwaukee power tools. This trigger spring is attached to main trigger. Please note that only trigger spring is included. When disassembling this area, be sure to slowly separate parts in order to prevent springs from being lost when released too quickly. Though they appear similar, a lockout spring is a different part used with the throttle lockout (not present in all models). This part is often purchased with: • Trigger, part # 545066001 • Throttle Lockout, part # 530059804 • Lockout Spring, part # 545045601

Fix Number

FIX8899813

Manufacturer Part Number

17804342230

This spring is sourced directly from the original equipment manufacturer for use with Echo handheld trimmers and edgers. It is an important component that applies tension on the trigger-throttle. Over time it may wear out and lose tension eventually requiring a replacement. To ensure the correct installation of this hardware, check the diagrams of your specific model. This high-quality spring is made of durable metal and is sold as an individual component. You will need a screwdriver to take apart the throttle housing when performing this repair.

Fix Number

FIX18788680

Manufacturer Part Number

679406001

This item has been sourced from the original manufacturer to ensure quality. The metal spring is intended to replace the original spring that would have come with the Ryobi trimmer. The spring is used to keep the switch in the correct position and to allow compression when the switch is actuated. This item is sold as an individual replacement part.

Fix Number

FIX11826669

Manufacturer Part Number

V452001520

This is an authentic Echo replacement part that has been sourced from the original manufacturer to be used with trimmers and power source attachments. The metal spring is used to apply torsion to the trigger to keep it in position and allow the trigger to compress when adjusting the motor's output. This item is available as an individual replacement part.

Fix Number

FIX8899474

Manufacturer Part Number

17723412220

This part is an authentic manufacturer-sourced replacement part which is specially designed for trimmers, brushcutters and blowers. This part is sold individually and made of metal. The return spring helps return the starter pawl back to the regular position after you are done starting the engine with the recoil starter.

Fix Number

FIX9246296

Manufacturer Part Number

V452000212

This is an authentic replacement part from original manufacturer. It is guaranteed compatible with the Echo tools listed below. This is a trigger return spring which attaches to the control handle and throttle trigger. During repair, be sure to note its positioning in relation to these other parts; correct orientation is essential for tool functioning. Springs are easily lost or broken so keeping a backup is a good idea. Sold individually.

Fix Number

FIX9242538

Manufacturer Part Number

V452000240

This is a genuine Echo replacement part that has been sourced from the original manufacturer to be used with edgers and Trimmers. The metal spring Lever Return is used to provide tension on the Lever of the trimmer to work out properly. This part is available as an individual replacement part. You will need a screwdriver to replace this part.