Shindaiwa Chainsaw Transmissions and Clutches

Fix Number

FIX9237267

Manufacturer Part Number

V651000011

This is a bevel gear, also referred to as a drive gear or tension gear, and is used in chainsaws. This authentically sourced part is sold individually. It is part of the chain tensioning assembly, aiding in loosening and tightening the chain on the chain bar. Once the chainsaw has be disassembled, the drive gear can be found on the underside of the clutch cover. You will need to remove the tension bracket screw, lift the adjustment assembly out, remove the bracket, and pull off the old bevel gear. Install the new bevel gear by sliding it onto the square end of the adjustment bolt, and reassemble.

Fix Number

FIX9246388

Manufacturer Part Number

V651000001

This is a single bevel gear for a chainsaw. Your chainsaw has two bevel gears that allow you to adjust the chain tension. One has a post with a slot in it (for a screwdriver), which mates to a second bevel gear that is attached to the adjustment screw. This part includes the bevel gear that has the post and screwdriver slot, the other bevel gear mentioned is sold separately, so it is wise to inspect both at the same time and order accordingly. The bevel gear is prone to wear, especially if the chain is over-tensioned, however this is a basic repair that should not take very long to complete.

Fix Number

FIX11826336

Manufacturer Part Number

A556000401

Fix Number

FIX10043367

Manufacturer Part Number

C320000182

Fix Number

FIX11826338

Manufacturer Part Number

A556001580

Fix Number

FIX17016318

Manufacturer Part Number

17500539134

Clutch Drum

Fix Number

FIX10041714

Manufacturer Part Number

A556000543

Fix Number

FIX11826235

Manufacturer Part Number

A056000181

Fix Number

FIX16478099

Manufacturer Part Number

A056000071

Fix Number

FIX11826237

Manufacturer Part Number

A056000221