Plastic Tube - 5/16 Inch

The original tubing from LG was cut exactly to fit. Had to remove the water filter inside the refrigerator. It was just one screw, so it came off very easily. The tubing connected to the filter at the rear with a quick disconnect. Very easy swap out. The tubing is also connected to the pump (located at the bottom of the refrigerator behin ... Read more d the cover plate. Only needed to take off 6 screws and one screw that held the pump on. The tubing was also held on to the pump with a quick disconnect as well. The tubing is secured to the rear of the refrigerator by plastic clips and screws. This replacement was extremely easy to do.

removed lower section at back of refrigerator for access to the solenoid valve, removed retaining clip and pressed in the retainer to release the hose, loosen hose clips on back to removed hose, removed cover at back of water filter and removed both retaining clips and pressed in retainer to removed hoses, removed filter inside of refrig ... Read more erator for access of screw holding filter housing, pulled forward to removed filter housing pulling hoses through. removed hose retainer and pressed in on retainer to removed hose. fit new hose. feed both hoses through the back of refrigerator. fit filter hose ,retainer and cover on hoses, Removed spring from old hose and fit to bottom of hose and installed new hose in solenoid, fit retaining clip and then route hose through hose clips on back of refrigerator. fit cover at lower back, install new filter and bleed air out. Check for leaks.