This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
Works with the following brands:
Frigidaire, Kenmore, Electrolux, Crosley
Works with the following products:
Fixes the following symptoms:
Too warm, Noisy, Won’t start, Fridge too warm
Part# 297309000 replaces these:
216914200, 216934100, 297250000, 5304442624, 7216914200, 7216934100
Show more, 7297250000
Videos For installing this part.
Replacing your FAN MOTOR EVAP 115V
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched. Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
September 17, 2022
Problem: freezer fine . Fridge won’t stay cold enough. Set at 37.keeps going to 40 and higher
For model number Ufhb2741pf4
Hello Annette, thank you for your question. We have researched your model and found that the issue is probably with the Evaporator Fan Motor, part number PS1526073. If that does not take care of the issue, then the problem is most likely to be related to the Temperature Sensor, part number PS1765215. If you require assistance to place an order, please contact customer service. We hope that helps!
I removed the panel in back of freezer with Philips screw driver then unplugged the motor from the freezer wire harness and removed the evaporator fan motor bracket with a nutdriver. Then you need to remove the fan motor from the bracket. Next I pulled the old fan blades from the used motor and put them on the new fan motor and attached to the mounting bracket and reversed my processes.
Unplug the freezer. Empty the freezer. Remove the shelves by removing the shelf spacers located on the right of each leg of each shelf and sliding them to the right, the left legs will pop out of their pockets, allowing removal. Remove the bottom tray assembly. Remove the 8 screws holding the back panel on (3 top, 2 center, 3 bottom). You may have to defrost the bottom of the freezer before you can remove the bottom 3 screws. NOTE: The thermostat is connected to the back panel, so carefully pull it out to expose the evaporator fan. Remove the two bolts holding the evaporator fan motor in. Disconnect the evaporator fan motor wiring harness. Lift out the evaporator fan motor. Gently pull the fan of off its spindle. Install the fan onto the spindle of the new evaporator fan motor. Install the new evaporator fan motor using the two previously removed bolts. Reconnect the wiring harness. Re-install the rear panel. NOTE: Make sure the drain located at the bottom of the freezer is not clogged/frozen - if it is, clear/unclog it, Re-install the bottom tray and the shelves. Plug the freezer back in. Close the freezer and allow it to get cold again, re-stock.
0 of 1 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Back to Top
This part works with the following models:
Fix Number: FIX3502361
Manufacturer Part Number: 297309000