This is a crank arm for a workmate, sold individually. It is also sometimes referred to as a handle arm. The hole that connects the crank to the shaft has a diameter of a 1/2-inch. The purpose of the crank arm is to open and close the front rear vise jaws. To assemble, place the crank arm over the vise screw rod end, line up the holes and secure the roll pin using a hammer.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
