Synchronous Motor

cut the cover...remove 2 screws..remove motor..replace new motor..All as per instructions someone else posted..however..replace cover and secure, no instructions on how to secure the cover..I used Duct tape...Works for me. By the way..I am a 76 year old female..If I can do this..anyone can.

Remove about 5 screws 4 from cover and one from synchronous motor mount,unplug cable, install new unit and reassemble

Remove loose parts from inside the oven. Turn the oven over onto its top, bottom facing up. There is an inspection cover on the bottom, roughly 3"x 5". If the inspection cover on the bottom has not been previously removed, use the diagonal cutters to cut the small tabs between some of the holes (+/- 10) and remove the inspection cover t ... Read more aking note of its orientation. Remove the two Phillips screws holding the motor in place, and unplug the power connector. Connect the power connector to the replacement motor, and reinstall the two screws, do not over tighten. Rotate the inspection cover 180 degrees from factory position, remove the single screw that was next to the inspection cover, insert the two tabs on the inspection cover into the slots on the bottom of the oven, and reinstall the previously unused screw to secure the inspection cover that has been rotated 180 degrees. Takes a lot of words to explain this 5 minute repair.

watched youtube video. it was easy to fix. small cut on finger from sharp metal housing-be careful