Drain Pump - 120V 60 Hz.

Replaced the drain pump

Remove 2 panel screws and 2 pump screws. Remove clamps. Reverse ..done

Just copy the video attach with parts order

Remove the top panel, control panel, remove the seal ring, the door switch, and then the front panel. Unhook to green hose clamps. Shop vac old water, remove the burned up drain motor by 2 mounting screws, unhook the power wire from old motor. And then reassemble with new motor.. Done

The parts arrived very quickly, considering our part of the country was recovering from a blizzard. The part was easy to install and we were washing clothes that evening.

Looked in my owner manuel and found the pump picture and got the pump number. Then called parts select and ordered the part. It was shipped in very fast time. Got the part and removed old pump, 2 screws holding pump in. 2 Clamps removed for the 2 hoses. Then put 2 screws back in and the clamps holding hoses. Then turned wash ... Read more er on and went a wash cycle and every thing worked fine.

Drain pump would only hum and not pump the water out. I ordered the part on Friday morning July 31st. The next morning ( Saturday Aug 1st) I started taking things apart to remove the pump and discovered that an underwire from a bra was preventing the pump from turning. After removing the item and cleaning out the coin basket of 62 cents a ... Read more nd part of a bra fastener. I reassembled the pump and the washer was working like it should. The new pump arrived about 45 mins later. I will keep the new pump in the event the pump ever fails. Easy fix. Also, an easy way the get the water out of the washer when the pump will not work is with a wet/dry shop vac attached the the drain line from the washer.

Took front off, removed old broken pump, installed new drain pump, put front back on. Easy and simple.

Disconnected from electric circuit./ unplug from wall. Move washer out from wall. Block up front to make assess easier. Remove lower front panel (2 screws). Keep large towel handy. Will loose some water when clamp/ tube is disconnected. Large clamp in back of drain hose is diffucult to remove unless you have the correct pliers (which I d ... Read more id Not). Disconnect electrical connectors. A bit difficult to get latch on wire connectors to release wire connector.. Remove screws from base of pump. Remove large wire clamp. Easy to get off, but difficult to put back on. Reverse proceedure to install. Note: Have large set of pliers to replace large drain hose. Close quarters to work in for large clamp replacement.