3rd Level Wash Spinner Kit

followed the video instructions and had to problems with the job from start to finish.

Good info from others who fixed this. Remember to put paper in bottom of dishwasher because you probably will drop parts. I noticed that the old spinner had a very petro-chemical smell so be sure to dispose of it promptly. Great to be able to make repairs without calling a serviceman

Remove both dish racks. Remove upper am screws on top and side of dishwasher. Remove any remaining pieces of old spinner, snap new spinner on arm. Replace screws, dishwasher ready to run.

Remove the two screws from the top water supply. This allows the assembly to bend forward. Place the new barb fitting on top and push the spinner up with the female connector to attach. It is easy to see that the old barb piece was worn. It would be better if t offered a package with two barbs and not the spinner.

Follow instructions provided by this site

Remove top rack. Remove top screw holding the water duct to the roof of the dishwasher, pull water duct down gently and remove old retainer pin. Insert new spinner with new pin retainer, push in new pin, reinstall screw to hold water duct to roof of dishwasher, replace top rack. Whole operation took no more than 2-3 minutes max.

Remove the top rack was easy just 2 plastic retaining clips from the rack slide rails. Pull the rack out to expose the wash spinner location. Remove 1 screw # 2 phillips head screw closet to the spinner. Pull down the plastic insert and your in snap in the new kit and reinstall the screw and top rack. 15 mins. Love this site. It helps yo ... Read more u folks fix anything.