Door/Light Switch

So I looked online and tired to figure out what it could be. And all I could find was people saying to change out the socket or light switch. So I did. And still nothing. Turns out when I screwed in the latest bulb I over screwed and the connector at the end where the bulb touches was pushed down and I just needed to bend it up with a fla ... Read more t heads boom. Parts where unnecessary but cheap enough I kept for future endeavors. Try this first before spending the money. Only way I found out was searching for problems even after new parts and stumbled upon a thread where someone else suggested this. Passing the knowledge. *even the new part I received needed to be bent up.

The repair was done with a small bladed common (flat bladed) screwdriver. Simply push the blade up the right side of the switch to relieve the clip pressure while pulling down on the switch. It might take a little pressure to get it to come out due to the wiring being on the left side of the switch. Pull the spade connectors off the switc ... Read more h and replace the switch with a new one. to install simply feed the wires back in the hole and press the switch into place. This is all done with the power off. Be safe!